Electronics Forum | Mon Jan 31 07:10:10 EST 2005 | pjc
What is the mfr'r? Electrovert? If so, go to them. www.speedlinetech.com There is still Atmos 2000CR ovens running in the field.
Electronics Forum | Tue Nov 07 06:36:39 EST 2023 | ravikumargv
Dear All. Good day.. We have one Omniexcel dual conveyor reflow and recently we had PC got gone bad and now we replaced new mother board and hard disk, but we don't have the previous PC backup, now we need the software. kindly help us to share the
Electronics Forum | Wed May 26 17:46:02 EDT 2004 | pjc
Electrovert has hard data on electrical and N2 consumption for the new OmniEXCEL series ovens to compare with preceeding OmniFlo series. Have a look.
Electronics Forum | Thu Oct 25 11:15:55 EDT 2012 | aj
are you sure the zone 5 blower is running? sounds like it isnt.... no harm to check all blowers while you are at it.
Electronics Forum | Mon Jun 24 13:01:24 EDT 2013 | quaker332007
Can anyone help me with the center support on this oven? The support is rising up to high and causing the board to rock during reflow. Is the away to lower the center support?
Electronics Forum | Fri Nov 17 03:41:38 EST 2023 | ravikumargv
Dear All, Any update for the below request. Please do the needful as soon as possible
Electronics Forum | Mon May 24 12:54:25 EDT 2004 | pjc
Maybe here's an opportunity to get a new oven. Electrovert, BTU and Vitronics offer closed-loop N2 control as an option. This, together with other improvements on oven design can reduce N2 consumption by as much as 40%. Not to mention reductions in e
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Thu Mar 01 14:35:52 EST 2012 | edmneb
We recently got a used Electrovert Bravo 8105 in house, but the unit did not come with any passwords to access the software. Any one know a default password, or way to change the passwords? Thanks!
winsouce.jpg)