Electronics Forum | Thu Aug 20 11:38:57 EDT 2020 | stephendo
You might have to adjust both ends to match the middle. Is it an autowidth oven?
Electronics Forum | Wed Aug 19 13:52:11 EDT 2020 | goldendragon
Hello guys, Please help me how to parallel the width chain, it is bow out in the middle and keep dropped the board in oven, I can't find anything there that I can manually adjust the middle width to the same size with the entrance and exit. HELP!!! T
Electronics Forum | Thu Aug 20 14:46:26 EDT 2020 | goldendragon
Yes, it's autowidth oven. I thought about manually adjust both end to match with the with the middle. Thank you very much! Tim
Electronics Forum | Wed Sep 27 15:57:33 EDT 2006 | SWAG
I wanted to post resolution on a reflow oven problem we had but can't seem to search out the old thread. So, this is new but old. Our OmniFlo 7 conveyor was stopping every once and a while and the speed indicator on screen said 1000+ ipm. We cle
Electronics Forum | Thu Aug 20 16:28:11 EDT 2020 | cyber_wolf
My guess is that someone either clamped a board or a ramp at the end while adjusting the width. I have had this issue before. Remove the rails and look down them like a gun sight. I have never had any luck trying to adjust out big bends. If you wan
Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu
180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and
Electronics Forum | Thu Aug 30 11:59:00 EDT 2001 | Spanky
Hey all, I have 3 questions about reflow. Hopefully someone can help me. 1. I am having a problem. I set the peak at 230 and my mole thermocouples are telling me the temp in that zone gets to 237. How is this possible even if the thermocouple
Electronics Forum | Wed Jan 19 14:43:51 EST 2011 | davidalvarez
Im looking for manuals + schematics and repair information for an electrovert omniflo 7e reflow oven manufactured in 1999, also intrested in the Bill Of Materials if available. Any information on where these can be obtained and where replacement part
Electronics Forum | Fri Nov 02 14:22:20 EDT 2012 | marcelll
Hi, I'm looking for a copy of the Omniflo oven firmware. I'm talking about the model running under Win NT. Oven vintage is 1999-2001. Our oven is a 7 zones but I thing there's only one firmware for all the Omniflo ( 7, 10 12 zones . The original was
Electronics Forum | Thu Feb 10 09:25:44 EST 2005 | lyrtech
Hi, Actually we're looking for a new reflow oven regarding lead-free process and higher capacity production. We have an opportunity for a second hand Electrovert Omniflo-7 (nitrous ready) that respect our budget. My questions are: Does anyone ha
