Electronics Forum | Tue May 07 09:26:38 EDT 2013 | emeto
Hello knowledgeable people, we have Omniflow 10Zone oven from 3-4 years and we changed over 20 blowers. The blower is German and I think is a very good quality(quite expensive too), but still keep getting bad. Does anyone have similar problem? Do yo
Electronics Forum | Tue May 07 12:27:23 EDT 2013 | hegemon
Seems really excessive. I am not familiar with that particular oven, but I would check to see that the fans are not seeing excess heat during use. Is there any ducting around the fans that might have leaky joints? Is there insulation around the fan
Electronics Forum | Mon Feb 28 21:42:27 EST 2022 | emeto
Wow this is 21 years old! Impressive.
Electronics Forum | Fri Mar 04 12:29:04 EST 2022 | stephendo
The Historical Society. 20 years old is antique for technology.
Electronics Forum | Fri Mar 04 10:44:54 EST 2022 | bukas
i got 14 machines from 1994 to 2001, where do I apply for medal? xD
Electronics Forum | Thu Mar 03 20:19:28 EST 2022 | astarotf
If our hard drive had scratches on the data lens, the needle was misaligned and caused the drive damage. The disk cannot be recovered.
Electronics Forum | Wed Feb 23 14:46:52 EST 2022 | astarotf
Hello everyone! We currently have a 10 zone oven, omniflow 10E, the CPU hard drive is bad and we don't have the installation files! neither the software nor anything. Does anyone know any contact or information related to this oven? I am looking fo
Electronics Forum | Wed Mar 02 22:11:30 EST 2022 | travishemen
I have successfully revived a dead hard drive by buying an the exact same model and swapping the circuit board from the new an presumably good hard drive to the drive I'm having trouble with. I have done this twice on hard drives that were between 1
Electronics Forum | Thu Aug 11 10:21:40 EDT 2005 | leonb
HI all, i have 2 omniflow 5 zone reflow ovens would these be suitable for rohs compliance also 2 iemme 760 reflow oven with 4 upper zone and 4 lower zones would these be suitable also any feed back would really help
Electronics Forum | Thu Sep 18 11:07:39 EDT 2003 | donbell
SR. Tech: I have worked with Omniflo 7 and 10 ovens for many years. I purchased several 10 zone ovens in '98 when I worked for Ericsson. Here are some of my experinces with Electrovert Omniflo ovens; Yes, you can expect to run the conveyor speed a
