Electronics Forum | Wed Dec 08 17:48:18 EST 2010 | katguts69
looking for schematics for electrovert omni 7 reflow oven. manufactured in 1998. help!
Electronics Forum | Thu Aug 30 11:59:00 EDT 2001 | Spanky
Hey all, I have 3 questions about reflow. Hopefully someone can help me. 1. I am having a problem. I set the peak at 230 and my mole thermocouples are telling me the temp in that zone gets to 237. How is this possible even if the thermocouple
Electronics Forum | Sat Jul 01 00:20:08 EDT 2017 | aemery
Kelly, it's been a long while since I repaired a BRAVO. The machine was a little unique as far as Electrovert ovens go. I am pretty sure that it is the only Speedline model that integrated a PLC. Loved the OMNI's, not so much with the Bravos. I a
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu
180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and
Electronics Forum | Wed Feb 23 18:27:12 EST 2005 | gpaelmo
Hi Indy, Check http://www.jmw-inc.com (they are in the midwest so shipping will not be too bad going out east). I bought 2 MPM printers and a pick and place machine from them late in 2004. I know they have 5-zone reflow and 7-zone ovens there (elect
Electronics Forum | Mon Jan 15 16:14:15 EST 2007 | leemeyer
This is a used oven, new to us. No product has been setup on it yet. We were establishing som baseline profiles and noticed that the actual profile read didn't even come close to our optimal profile. Further investigation proved that the belt was to
Electronics Forum | Wed Aug 19 13:52:11 EDT 2020 | goldendragon
Hello guys, Please help me how to parallel the width chain, it is bow out in the middle and keep dropped the board in oven, I can't find anything there that I can manually adjust the middle width to the same size with the entrance and exit. HELP!!! T
Electronics Forum | Thu Aug 20 14:46:26 EDT 2020 | goldendragon
Yes, it's autowidth oven. I thought about manually adjust both end to match with the with the middle. Thank you very much! Tim
Electronics Forum | Wed Aug 01 11:26:13 EDT 2012 | davemac62
Looking for a manual for Elecrovert Omniflo 7 Reflow Oven. Anyone got an extra copy? Mine seems to have walked off :O/
