Electronics Forum | Wed Dec 08 17:48:18 EST 2010 | katguts69
looking for schematics for electrovert omni 7 reflow oven. manufactured in 1998. help!
Electronics Forum | Thu Aug 30 11:59:00 EDT 2001 | Spanky
Hey all, I have 3 questions about reflow. Hopefully someone can help me. 1. I am having a problem. I set the peak at 230 and my mole thermocouples are telling me the temp in that zone gets to 237. How is this possible even if the thermocouple
Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu
180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and
Electronics Forum | Wed Feb 23 18:27:12 EST 2005 | gpaelmo
Hi Indy, Check http://www.jmw-inc.com (they are in the midwest so shipping will not be too bad going out east). I bought 2 MPM printers and a pick and place machine from them late in 2004. I know they have 5-zone reflow and 7-zone ovens there (elect
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Tue Dec 07 15:03:16 EST 2004 | Nat
Hi all, We have an Omniflow 7 reflow oven that has not come with the nitrogen option. We are looking at fitting a nitrogen system to the oven, does anyone have nay knowledge that may help us? The cost of the nitrogen is nothing as we outgas enourmou
Electronics Forum | Mon Jun 24 13:01:24 EDT 2013 | quaker332007
Can anyone help me with the center support on this oven? The support is rising up to high and causing the board to rock during reflow. Is the away to lower the center support?
Electronics Forum | Tue Oct 26 10:49:00 EDT 2004 | Simon UK
Hi, > > I'm planning to get a new oven. I wanna > know the advantages and disadvantages of each > oven type over each other. I'm being told to go > for an 8 zone oven. > > thanks for your > help. > > regards, Depends really if you want a dua
Electronics Forum | Fri Jun 26 10:33:08 EDT 2015 | Asif
Hello Professionals, Good morning, We are circuit card manufacturer for the Aerospace industry with low volume and High mix level. We have a plan to Purchase a NEW REFLOW OVEN. Currently we are using Electrovert BRAVO reflow oven which is about 8 yea
Electronics Forum | Mon Jan 19 08:37:16 EST 2009 | lkpdsund
Hello all! We possess a speedline electrovert omniflo 7 reflow oven at my site. Last week we examined how the solder profile was affected by fan-speed and by providing the soldering process with compressed air(O2) or nitrogen(N2). We also ran the sa
winsouce.jpg)