Electronics Forum | Wed May 26 14:24:13 EDT 1999 | Boca
| | we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any o
Electronics Forum | Tue Aug 13 17:34:44 EDT 2002 | pjc
The Electra is Electrovert's top-of-the-line wave solder machine. Just about the best you could get. Conveyor concerns should focus on the condition of the extruded rails. A machine that new should not have a problem, buy worth a look see. Find out i
Electronics Forum | Wed May 26 15:56:08 EDT 1999 | Chrys Shea
| | | we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any
Electronics Forum | Mon Dec 21 08:49:29 EST 1998 | Aric Parr
I used one on SMT at a previous employer. Make sure that you have 3 zones of preheat. Make sure that your operators are trained. The airknifes are extremely difficult to set up properly. Don't use them on high mix lines. We didn't need them once
Electronics Forum | Thu Jul 13 04:01:02 EDT 2000 | JohnW
Dave, Firstly..how the heck are you?..been a while.... Ok so I'm running an Electrovert Electra witha hot gas knife, & I've got large server boards going over the wave. I've seen us loose chip, mainly Tants on the hot gas knife...ain't good especia
Electronics Forum | Fri Apr 23 15:10:45 EDT 1999 | Chrys Shea
| We are an assembly house engaged in large volume manufacturing of Computer motherboards and others. We are in the process of selection of a new wave soldering machine. Can somebody help me inform what are the different parameters which must be ens
Electronics Forum | Fri Oct 23 16:01:18 EDT 1998 | Earl Moon
| I need some info on how to stop the bridges I'm having on | radial and axial parts that are in the same place on every board. I'm also having problems with sot-25 bridging. I'm using a Electrovert E-pak. I tried leveling the machine,solder pot, an
Electronics Forum | Tue Jan 28 18:38:36 EST 2003 | joeherz
Mike, I've tried the high side of the flux preheat spec with no success. I did just get off the phone with Electrovert tech support...... Get ready. This machine is configured with a Contour Plus N2 nozzle. We are not running N2. According to M
Electronics Forum | Tue Mar 11 18:01:26 EST 2003 | russ
Tim, I cannot remember what model our T.D. wave was it was a small unit about 8 ft. long "tabletop" is what I call them. In keeping up with this thread I noticed a lot of T.D. support. So, I decided to backtrack and review history with my previous pe
Electronics Forum | Wed Jun 24 13:46:41 EDT 1998 | Chris Kelly
Brian, a couple of things really stick out here... 1) You are spraying what is referred to here at the CATT as "PINK DEATH" The 3355-11 is about the most active/aggressive flux you can get your hands on. I am concerned about both the condition