Electronics Forum | Mon May 08 16:01:11 EDT 2000 | John
I was running the conveyor at 3.75 when we started the discussion with Electrovert. Unfortunately, foam fluxing is a fact of life for us. Our products have open contact relays that can become contaminated by spray fluxing. Titration is our only me
Electronics Forum | Fri Jan 13 22:57:19 EST 2006 | John
The New Redesigned Vectra , should fit right into the same price range as most mid-range wavesolder machines offer by most. We are looking to replace a existing Delta Wave and found the pricing about the same.But The upgrade prices can be high for no
Electronics Forum | Mon Mar 07 22:23:40 EST 2005 | mrduckmann2000
Ken, You nailed it! We have a Electrovert Vectra wave solder machine that will erupt solder all over the place while heating up, we had to disable the timer because of all the solder splatering. Electrovert told us that our machine had a small des
Electronics Forum | Fri May 05 14:30:11 EDT 2000 | C.K.
I'd have to disagree with the Electrovert applications guy. I'd recommend SLOWING down the conveyor between .5 to 1 FPM - effectively, you're REDUCING contact length (because contact length = dwell time * conveyor speed), hence getting better peel-o
Electronics Forum | Mon Jun 13 11:48:33 EDT 2005 | CMiller
We got a F04 error (internal Memory fault) on the shared drive and entered 8 in location N001 as per the maint manual and cycled the power. I then set all the locations listed in the manual to thier default settings. Now the motors do not run to thei
