Electronics Forum | Mon May 14 08:53:42 EDT 2007 | realchunks
Can't do much better than Electrovert. http://cgi.ebay.com/SPEEDLINE-ELECTROVERT-ULTRAPAK-445-16-WAVE-SOLDER-MACH_W0QQitemZ220111865148QQihZ012QQcategoryZ58293QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
Electronics Forum | Mon May 14 17:06:41 EDT 2007 | russ
You can get a nice used electrovert in your budget.
Electronics Forum | Mon May 14 13:56:54 EDT 2007 | jdumont
Agreed, I just bought a Electrovert Vectra Elite and have been very pleased with it thus far. I got the dual pot option for lead free changeovers and that has worked great. I can change pots in under 5 minutes, not counting the time to warm up.
Electronics Forum | Thu May 17 09:00:51 EDT 2007 | bsteffen
Since your budget is between 25 and 30K I would say you have plenty of options. Electrovert and Vitronics are both good solid machines. Seho is another option. Seho is extremely user frendly and maintenance freindly and easy to profile however, it is
Electronics Forum | Wed May 16 14:48:07 EDT 2007 | jdumont
We got a good deal on ours for around $100K new with not many options. For what its worth I visited Novastar's factory in Pa and was not happy with what I saw there. There were almost no static precautions taken, boards were stacked in cardboard boxe
Electronics Forum | Fri Aug 01 09:44:42 EDT 2008 | pjc
Try Zestron Vigon RC 101. This mixes with tap water. Electrovert does not recommend DI water due to its corrosive nature. http://www.zestron.com/fileadmin/zestron/overviews-tis/usa/ti/ti-vigon-rc101-usa.pdf
Electronics Forum | Mon Jun 12 11:07:17 EDT 2000 | Jason
after reading some other problems i can tell you that we have an electrovert wave and are using alcohol base flux with convection preheaters. also we are spraying it on...not foaming. we are using an omega wave also. thanks again...if you need mor
Electronics Forum | Wed Feb 12 20:13:39 EST 2003 | cmiller
Does anyone have any experience with setting up a nitrogen supply system to a wave solder machine that is equiped for it? Does the nitrogen need to be room temp or higher? Does it make a big difference with bridging or solder quality? We bought a use
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Fri Jan 21 11:15:28 EST 2005 | russ
Are you running any type of vibratory wave on the Vitronics as opposed to the electrovert? How about any turbulent wave differences if any? The only time I have ever flooded boards in fixtures is when the seal is broken or run an excess amount of v
winsouce.jpg)