Electronics Forum | Wed Apr 30 07:39:29 EDT 2008 | realchunks
Is the green box on top of the transformer? If so you can by-pass it.
Electronics Forum | Wed Apr 30 07:03:07 EDT 2008 | gemengr
DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that lit
Electronics Forum | Wed Apr 30 07:45:05 EDT 2008 | gemengr
Yes, it is. there's a heat sensor under of 4 resister,look like it open now.I'm thinking to make a jumper right there to see it can power up the machine.(this's a little green box on top of the transformer)
Electronics Forum | Wed May 19 17:54:41 EDT 2010 | gregcr
I have had problems corrected by swapping or replacing the power supplies in the box. Do you have a second GSM that runs the AIS3500 box? If so swap the power supply and see if the problem follows the swap. I have replaced the supplies inside the
Electronics Forum | Tue Apr 16 09:58:10 EDT 2019 | ttheis
Resolved; the power box "service" switch was set to ON. Changed to OFF and machine powered up per instructions. Didn't see this switch mentioned anywhere in the power up procedure. Thanks to the previous owner for tipping me off.
Electronics Forum | Wed Jan 21 09:18:10 EST 2009 | gidster
The MPA is jul 94 it has a transformer. The drawing is just a picture of the power source box. Regards mark
Electronics Forum | Sun Nov 22 17:52:49 EST 2015 | wesleyintelli
Hi Deni, Thanks for your interest in my problem. It turned out that the power supply to the VGA vision board (the system in the black box)was faulty. I replaced it with a universal PC power supply and all is well.
Electronics Forum | Sat Oct 10 02:59:53 EDT 2015 | aemery
AVCOM, I have worked on a few of the Conceptronic ovens recently for one of my clients. They had a similar issue, all the heaters dropping out with a high temp circuit error which kicks out CON1 (Heater power). If you're saying what I think your sa
Electronics Forum | Tue Jan 04 13:00:07 EST 2011 | bk
The only x fan i can think of would be the x belt motor fan which is on the back of the black box sticking out of the back of the machine. If it's a heat issue then first thing to do is replace the 2 filters behind the 2 vented covers located on the
Electronics Forum | Mon Nov 23 13:46:14 EST 2015 | dilogic
It is written on power-up screen after booting USOS (green letters). I am attaching image of mine, but with newer VME630 vision. If yours shows AIS3500 there, it is probably a problem with video DAC inside that box (located on the machine rear end, a
