Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder
I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca
Electronics Forum | Tue Apr 27 13:41:16 EDT 1999 | Scott McKee
| i am trying to design a stencil fixture for manual printing. has anyone done this before or has an idea? thanks | There are sooo many variables; product size, 1 vs. 2 sided boards, support, component size, pitch, stencil alignment, PCB thickness,
Electronics Forum | Mon Mar 19 09:37:01 EDT 2018 | spoiltforchoice
Another critical part of a process with a large board is support. Most commonly this is a bed of pins e.g something like red-e-set but there are other solutions. Support with a large panel will be critical for printing to get a good gasket between PC
| 1 |
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
