Electronics Forum | Wed Feb 06 11:24:19 EST 2002 | mrpsilva
Thanks in advance for your help. I am looking for the following board: MYDATA � Elmo EBAF 25/400RHI � controller for X axis If you need pictures, please let me know in order to send you Thanks Marcos
Electronics Forum | Tue Mar 18 11:02:44 EDT 2014 | proy
I have a Camalot MOtion control board which does not control its Z axis properly. Can anyone here recommend someone who can repair this? Peter
Electronics Forum | Wed Jun 08 13:16:02 EDT 2005 | cyber_wolf
It sounds to me like it may be your squeegee Z motion controller card. The SQUEEGEE Z motion controller card is interchangeable with some of the other motion cards in the back of the machine.(NOT ALL OF THEM) Make sure you look at the power ratings a
Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake
Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I
Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
Electronics Forum | Thu Jul 22 11:51:49 EDT 2004 | Steve
I have found a company called Cleveland Motion Control that will fix them for a flat fee. Did a little searching and found them using Altavista.com Cheers
Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Tue Sep 30 12:09:45 EDT 2014 | tech1
If you are running a Mydata machine why don't you try one of the new stick magazines they offer. These magazines shake rather than vibe and the motion is controlled by the package dimensions. Call your rep and see if you can "borrow" one to try out.
.gif)
