Electronics Forum | Wed Jun 24 10:17:50 EDT 2020 | kylehunter
> Hi. Guessing that you are operational by now? If > not, consider to use BGA definition and use the > editor to define where the bottom side pads are > or are not. Just our 2 bits input. The Assembleon > X / Yamaha units are quite
Electronics Forum | Thu Jul 15 15:57:39 EDT 2021 | kumarb
Here you go: https://we.tl/t-qQkEpE8H3p Suggest to also contact Trans-tec USA for any questions that you may have about this tool or any other. As an owner of the machine from Assembleon / Yamaha - they offer support. They have been great to suppo
Electronics Forum | Tue Jun 24 10:25:55 EDT 2008 | jdengler
I have a Philips Assembleon Topaz (not an X or XII, just Topaz), that we got from a broker or "what have you". See your statement above.
Electronics Forum | Mon Jun 23 19:33:09 EDT 2008 | adamcrum
Hello, I have a Philips Assembleon Topaz (not an X or XII, just Topaz), that we got from a broker or what have you. I just did a complete rebuild of the head assembly after some of the shaft bearings went out and was getting ready to do the auto moun
Electronics Forum | Thu Dec 05 08:49:43 EST 2002 | pjc
Yamaha YV100Xg is the Topaz XII YV100X is Topaz X YV100II is Topaz YV88Xg is Emerald XII YV88X is Emerald X YVL88II is Emerald YV180Xg is Sapphire XII
Electronics Forum | Thu Mar 17 05:24:15 EDT 2016 | robl
Hi Ermami, You can on the base Sapphire (non x or xii) - it's switches on the Connection Board, I'm guessing it's the same for the X & Xii, although they are pretty rare. It's in the Sapphire Service Manual, and also in the Topaz & Emerald X & Xi
Electronics Forum | Mon Sep 01 05:05:06 EDT 2014 | max83
Hi, Very good machine. They has different calibration procedure little bit compared with Topaz Xii. It has linear guides. in the general not so much different from Topaz Xii. Were you from?
Electronics Forum | Fri May 22 06:56:45 EDT 2020 | compit
Is Topaz-Xii or Emerald? Write, I'll check what I have in the evening. Send me e-mail address.
Electronics Forum | Fri May 22 07:01:30 EDT 2020 | joost
Its a Assembleon Emerald Xii. Thank you very much. I wil private message you my email
Electronics Forum | Mon Jun 08 09:20:57 EDT 2020 | vinitverma
Since it is an Emerald XII, I suppose it is Windows and not VIOS. Go to Optimize and select "Convert with Note Data". This will convert all blocks to single PCB and keep a NOTE of original Block Data so that you can convert back to block if and when