Electronics Forum | Tue Apr 07 19:36:41 EDT 1998 | LEON MARTIN
WE ARE TRING TO LOCATE A 9 SEGMENT, INFRARED EMITTER ARRAY & 9 SEGMENT INFRARED DETECTOR ARRAY. THEY ARE USED IN A COIN READER TO MEASURE THE DIAMETER OF THE COIN. THE SIZE OF THE ARRAYS ARE, 1.6 BY .297 INCHES. ANY HELP WILL BE APPRECIATED.
Electronics Forum | Wed Jan 18 16:03:08 EST 2006 | Klevesqu@vtc.edu
Hello, I am wondering where I can purchase and read up on the specs for the proper solder flux pastes for Luxeon emitters. I notice in there aplication briefs they mention 380SR-flux gel and a few others but I no clue if that is a model number or wha
Electronics Forum | Wed Jul 01 11:48:30 EDT 2015 | sssvajunas
We use component BFU730LX and we have one problem. After reflow transistor base or collector lands are not soldered. Maybe someone have similar problems with this component? We tryed to change stencil pads (smaller , bigger) but problem is the same.
Electronics Forum | Wed Jul 22 16:04:52 EDT 2020 | jordanabshire
Here in this circuit LED is placed at the collector. i am with an impression that, IE=IB+IC. so it is better to keep at the emitter, right ? all the gain of the transistors are not utilized. What is the purpose of LED, placing at collector? Please e
Electronics Forum | Wed Jul 22 16:39:28 EDT 2020 | emeto
You did not attach anything here. Transistor can be connected in different circuit(like common Emitter) and will use Collector current as output. Also Ic is about the same as Ie in value, as base current Ib is insignificant usually in uA.
Electronics Forum | Thu Feb 15 16:01:53 EST 2007 | jdengler
Bert, Clean the emitter disk of the nozzle you use for this part. Set everything in the PD back to where it should be and set the "Lead_check_area" to 10. This will look at 10% of the end of the leads. This will help if the leads do not have even
Electronics Forum | Thu Jun 19 12:18:45 EDT 2014 | haiae
There are two IR sensor (one for tipdown detector and other one for tipup detector) for each tip in each head. You should check infrared sensor for Head2 tip1, that cause may be by dirty between IR emitter and IR receiver. Just clean it and try to ru
Electronics Forum | Mon Apr 08 18:16:20 EDT 2024 | mistrthou
We had a Mycronic tech in adjusting rings to get us within spec. He was saying the emitter/receiver board at the top and the tubes themselves can go bad. Between that and having weak latches, we're looking at a refurbished unit. But we're rocking a M
Electronics Forum | Wed Jan 18 16:30:30 EST 2006 | davef
380SR-flux gel is sold by Cobar. Look here: http://www.lumileds.com/pdfs/AB10.PDF This application note suggests: * �#1;Metals 390DH4 * �#1;Metals LR735 * �#1;Metals NS4029 * ESP 6#1;412 * Cobar 380SR#1;flux gel Comments are: * "�#1;Metals" is "A
Electronics Forum | Tue Nov 25 05:40:52 EST 2008 | wanderson
Calibration menu and then Index Cam Setup and follow the on screen instructions. (You can skip the focus step if you have not adjusted the camera's) The point you need to pay particular attention to is when it displays the intensity histogram, this
winsouce.jpg)
