Electronics Forum | Mon Sep 24 09:50:37 EDT 2012 | davef
Try: * Danaher Controls Dynapar encoders * Encoder Products Company rotary encoders * BEI trademark encoder * khaid.instek@gmail.com)
Electronics Forum | Mon Sep 27 12:01:19 EDT 2004 | lgroves
John, My best guess is the "Y" encoder - or the encoder cable. The encoder is a part of the motor assy on the QSA-
Electronics Forum | Mon Feb 01 21:39:51 EST 2021 | dekhead
Most probable is encoder feedback failure... check encoder connections.
Electronics Forum | Thu Oct 27 03:15:14 EDT 2005 | Jeff Roberts
The Y-axis motor of the YM84 Series is well known for failures. The bearing between the encoder and the armature fails causing dirt to fall on the encoder wheel, hence the encoder mis-counts. If you re-Origin the machine the problem is resolved for a
Electronics Forum | Fri Sep 14 13:00:28 EDT 2012 | mark25y2001
Try to check encoder if properly locked, also check encoder connector if properley inserted, if all good, it's possible that the conveyor controller or encoder problem... to check controller related just try to set in zero value, then if conveyor are
Electronics Forum | Wed Oct 03 22:25:01 EDT 2012 | haiae
After many trying to find equivalent Renco encoder for my Contact 3AVX, I get it. My machine is running well without any errors after installing a new Rencode encoder. I hope, this message can help some one who has the same problem as my problem. Ple
Electronics Forum | Mon Sep 24 00:47:27 EDT 2012 | haiae
I'm looking for a new or used Renco Encoder with P/N 77676-295. Everyone out there know where can buy it please tell me. Attached is foto of my Encoder for reference. Many thanks,
Electronics Forum | Wed Sep 26 00:16:37 EDT 2012 | haiae
Thank you for your suggestion. I checked these link, but did not find equivalent encoder for replacement. My renco encoder is for Servo motor of Contact 3AVX machine. Did you know about this machine? Regards,
Electronics Forum | Fri Apr 01 16:55:56 EDT 2022 | SMTA-64387687
It could certainly be the motor and/or the encoder. They do go bad. The other thing to look at is the component/package. Does it happen with only one specific component/package? It might be corrupted data. That happens, as well. But, most likely it's
Electronics Forum | Thu Feb 14 00:05:50 EST 2008 | keithej2
Anyone ever seen an X1 encoder alarm on an IP3? We get it soon after power up and the x1 axis never locks. We have a motor/encoder on order but I've never seen this error message and am not positive that will fix it.
