Electronics Forum | Fri Sep 22 16:21:31 EDT 2006 | patrickbruneel
Figure 1. Human Toxicity Potential, Life-cycle Comparison Tin/lead solder paste is the top formula. SAC is second from the bottom.3 RoHS Report Excludes Comparisons By George A. Riley, contributing editor A European Union (EU) Commission for Envir
Electronics Forum | Wed Oct 11 09:04:37 EDT 2017 | sumote
I am looking for a source of metal pins. The rough dimensions are 0.500” long, and 0.025” x 0.025” square. They will be soldered to circuit cards on both ends, so must be a solder able metal. No special needs in the strength area, i just need a good
Electronics Forum | Thu Aug 07 13:13:51 EDT 2003 | mantis
Its been awjile since i was on a Cp643e but it sounds like there is a difference between the table board width and the fast loader width,when a board is to be transfered from the fast loader to the table the knuckles on the fast loader mechanism shou
Electronics Forum | Wed Dec 12 19:37:52 EST 2007 | marcelll
On a old VIP 98 oven. Since we reload the software, we have a problem with the board tracking system. Board is flagging the entrance pcell, we can see it on the graphic screen, but alarming all the time when at exit end. Alarm is "board droped in ove
Electronics Forum | Wed Mar 20 13:49:15 EST 2002 | cabjerk
Hi All; The following is from our Support people who worked with Fuji on the problem; Last week Luke Mittur and John Gudel were in from Fuji to address the IP3 issue outlined below. The problem ended up being that the table "up" and table "dow
Electronics Forum | Mon Sep 20 18:27:13 EDT 2010 | ratsalad
dman, This happened to me once on a GSX, but the head was not all the way up. I ended up shutting the machine down, inserting a bypass key so it thought the head was lowered then turning it back on. Then I told it I wanted to raise the head, hit
Electronics Forum | Sat Sep 16 12:49:36 EDT 2006 | magszoo
I'm hoping that someone may be able to shed some light on this error we've been getting on our DEK 265LT printer. Several months ago we began getting a "Rising table position error" after the operator would open the hood to load paste or after changi
Electronics Forum | Thu Apr 02 11:41:26 EST 1998 | Scott Cook
| Hello, | We are currently trying to design and ultimately implement a system that will be able to count and manage component placement for three Sanyo chipshooters on three SMT lines. | As the number of components decreases in the reels we want to
Electronics Forum | Thu Jun 15 04:12:12 EDT 2006 | Rob
I agree with Dave, we looked at it, but they can go walkies, and also people tread on them, drop things on them, mess with the programs etc. We (the IT dept, not me)ended up writing a Visual basic program & put a PC at every inspection station, li
Electronics Forum | Wed Apr 22 14:57:46 EDT 2020 | travishemen
It seems like we had a similar issue once on a CP643. If I remember right it ended up being either pre or post theta. The amplifier for the sensor quit working and it was trying to zero the theta motors before doing the cam. The LED indicator on t
.gif)
