Electronics Forum | Mon Dec 03 08:25:29 EST 2018 | proceng1
I have a Heller 1808 Reflow oven with the chain that has the edge hold to keep the boards off of the mesh belt. The feed end was more narrow than the exit end, and some boards would fall off. So we adjusted both ends to be the same. Well now, when
Electronics Forum | Fri May 06 21:49:46 EDT 2005 | Infinity
Thanks for your advice. I agree with carrying both high end and low end tools. Thanks!
Electronics Forum | Thu Jan 29 12:57:37 EST 2009 | wavemasterlarry
Only if it has exposed ends on the end.
Electronics Forum | Mon Nov 25 13:00:12 EST 2002 | steve
Ersa is the choice for lower end repair and rework systems. Airvac is the choice for higher end systems. Stay away from low end hot air units. They typically do not present an even flow of heat across the component. The Ersa requires no nozzles, whic
Electronics Forum | Tue Sep 23 14:29:34 EDT 2008 | realchunks
I have shlves with rollers and a stop on one end. Boxes go in one end and roll towards the other. One end for people to pull from, the other is to load. I have bunch left over and willing to sell cheap. Let me know if you want them.
Electronics Forum | Wed Dec 03 10:24:31 EST 2008 | vleasher
Our UIC Lightning Head is having pick issues with Vishay reels (0402,0603) when the reel are near the end. It occurs ~300-200 pieces before the end of the reel. Pick point was confirmed and is consistent. Has anyone experienced this issue nearing the
Electronics Forum | Tue Dec 26 11:26:00 EST 2000 | acahill
If you have a known problem with the parts, then Reject them back to the Vendor. It appears that you have a solderability issue. As for Tombstoning on 0402 chips, this could trace back to the stencil design and/or machine placement. Define Tombstoni
Electronics Forum | Wed Mar 02 09:19:15 EST 2005 | Dilbert
You probably are aware of this, but somehow get the conditioning unit as close to the sensor as you can. It sounds like the problem is the "long twisted pair shielded cable". Try different means of shielding, connect the shield at the end that has
Electronics Forum | Fri Aug 31 12:21:39 EDT 2007 | electronhose
With this length, I would use solid bare wire, solder one end, sleeve with approved shrink tube, solder the other end and shrink the tubing. You could even leave the shrink tube off if you had design clearance. Then you can just trim off the ends on
Electronics Forum | Sat Jul 23 01:51:04 EDT 2022 | poly
You'll find a lot of guides for cutting aluminium on the internet but basically, try and use a bigger end mill if you can, keep it at the right speed (not slower). We cut 1.6mm aluminium with a 3mm end mill. Smaller end mills didn't evacuate the chip
