Electronics Forum | Wed Jan 07 09:38:22 EST 2009 | grayman
Hello, Electricity cost is getting high. May I know from you if you have �energy conservation� programs? Right now we implemented the following programs: Purchased an inverter type aircon system (office aircon turn off 30 minutes before going home),
Electronics Forum | Mon Apr 06 17:11:20 EDT 1998 | Reza Paidar
Hi, I have been assigned to purchase a SMT assembly line for electronic ballasts used in compact energy saving lamps. I have the circuit and list of components, but know nothing about SMT. Could anybody tell me where to start and what to look for.
Electronics Forum | Thu May 17 10:47:36 EDT 2007 | floydf
My boss posed me an interesting question: would it save energy to leave the wave solder machine on all night instead of turning it off each night? We run 1 shift, and have timers on our machines. My instinct is that it would be cheaper to turn off th
Electronics Forum | Tue Jun 12 08:01:24 EDT 2007 | hussman
So, does turning off your glue gun at nite save energy or should you just leave it on? LOL!
Electronics Forum | Thu Jan 27 20:17:25 EST 2022 | stephendo
What exactly counts as "always on"? Our ROHS wave solder machine is always on during the week but the pot shuts off at the end of the shift and turns on early in the morning so that the solder is melted before we get to work. It is only using a small
Electronics Forum | Mon Jan 03 12:39:46 EST 2022 | vasu278
Is it necessary to set adjustment mode 2 during calibration but iam unable to change the setting after changing unable to save and the screen appears as shown in image below
Electronics Forum | Wed Jun 06 15:59:25 EDT 2007 | chrisawallace
WML, I won't dispute math but I will definitely point out either bad math or a missed target. In your example, you are comparing "Energy used to heat the solder and keep it warm" versus "Energy used to keep the solder warm" and fully discount the fa
Electronics Forum | Fri May 10 01:30:15 EDT 2024 | nicholascarson
Access the Calibration Screen: Navigate to the system settings menu on the HMI and find the calibration option. This may require entering a password or accessing a service mode, depending on the machine's security settings. Begin Calibration: Once
Electronics Forum | Tue Aug 22 12:37:06 EDT 2000 | Wolfgang Busko
Hi James, the problem is, it�s not gonna work with foam fluxers. The problem with preheating didn�t occur to me, I got it to the desired limits using pallets. This might depend on the abilities of the used machine. If it�s working with your sprayflux
Electronics Forum | Mon Apr 06 17:58:28 EDT 1998 | Wayne Bracy
| Hi, | I have been assigned to purchase a SMT assembly line for | electronic ballasts used in compact energy saving lamps. | I have the circuit and list of components, but know nothing | about SMT. | Could anybody tell me where to start and what
