Electronics Forum | Mon Jan 03 16:34:10 EST 2005 | davef
The main advantage if ENIG over HASL is that ENIG is flat and HASL generally is not. The main disadvanages to ENIG over HASL are: * Cost of ENIG is 1.5 - 2X higher than HASL * Selflife is less than HASL * You solder to nickel, rather than copper * E
Electronics Forum | Fri Oct 14 16:51:46 EDT 2005 | GS
It stands for Elettroless Nikel Immersion Gold, a kind of PCB finishing Entek (there are several kinds) is a brand name of an OSP (Organic Solderability Preservative)kind of PCB finishing. Regards............GS
Electronics Forum | Tue Jan 04 12:37:41 EST 2005 | Cmiller
We have been using this finish almost exclusively for fine pitch boards for about 5 years. Make SURE you use a board house that does the gold plating in-house. There are some potential issues as DaveF stated. The only problem we have encountered is w
Electronics Forum | Mon Aug 16 11:49:44 EDT 2004 | Kris
Hi Guys thanks for the replies. Dave, the spec is not for enig but for hard gold does your response alter if thats the case /
Electronics Forum | Mon Aug 16 16:26:19 EDT 2004 | Kris
what about areas that are soldered ? This is def not a Enig process and the specs are as they are not sure why thanks a lot for your help
Electronics Forum | Mon Aug 16 13:18:46 EDT 2004 | davef
You bet our reponse changes. Q2R: Hard gold thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel A2R: This is a hard gold spec?? It looks like a ENIG spec. Although, the Ni is quite heavy, 150 uin is sufficient for most applications. The gol
Electronics Forum | Mon Aug 16 16:37:08 EDT 2004 | davef
As we mentioned in an earlier response in this thread [Q5], you do NOT want to solder to hard gold. Hard gold is a wear surface. [That's IT, that's the LIST.] If you want to solder to gold, then either use: * IPC-4552 ENIG specification, mentioned
Electronics Forum | Wed Aug 11 18:36:03 EDT 2004 | davef
90 Knoop. Q2: Thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel A2: This looks like a ENIG spec. Although, the Ni is quite heavy, 150 uin is sufficient for most applications. [IPC-4552 ENIG specification: * Gold thickness of 0.075 - 0.125
Electronics Forum | Wed Dec 28 03:33:31 EST 2005 | sparrow
I would like to know if ENIG is widely used for the thermosonic gold wire bonding or this application is an exotic one. And I also wold like to talk to someone who uses printed circuits with ENIG finish for such an application. I do not quite underst
Electronics Forum | Thu Dec 29 03:57:16 EST 2005 | sparrow
Hello Chris, To be honest, it's hard to believe you could not bond to ENIG at all. Yes, the gold layer is thin and hard, but it just narrows the process window and does not make the bonding impossible. I say this, because we have been using TS gold w