Electronics Forum | Mon Aug 16 11:49:44 EDT 2004 | Kris
Hi Guys thanks for the replies. Dave, the spec is not for enig but for hard gold does your response alter if thats the case /
Electronics Forum | Mon Aug 16 16:37:08 EDT 2004 | davef
As we mentioned in an earlier response in this thread [Q5], you do NOT want to solder to hard gold. Hard gold is a wear surface. [That's IT, that's the LIST.] If you want to solder to gold, then either use: * IPC-4552 ENIG specification, mentioned
Electronics Forum | Mon Aug 16 13:18:46 EDT 2004 | davef
You bet our reponse changes. Q2R: Hard gold thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel A2R: This is a hard gold spec?? It looks like a ENIG spec. Although, the Ni is quite heavy, 150 uin is sufficient for most applications. The gol
Electronics Forum | Wed Aug 11 18:36:03 EDT 2004 | davef
90 Knoop. Q2: Thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel A2: This looks like a ENIG spec. Although, the Ni is quite heavy, 150 uin is sufficient for most applications. [IPC-4552 ENIG specification: * Gold thickness of 0.075 - 0.125
Electronics Forum | Mon Aug 16 16:26:19 EDT 2004 | Kris
what about areas that are soldered ? This is def not a Enig process and the specs are as they are not sure why thanks a lot for your help
Electronics Forum | Wed Aug 11 16:09:50 EDT 2004 | Kris
Hi How does one distinquish between hard gold and immersion gold ? thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel what happens if the gold drops below 3" and the nickel is above 350" what are the typical failure modes associated with
Electronics Forum | Thu Aug 12 14:50:12 EDT 2004 | russ
This is interesting, I was once told by a PCB supplier that "soft gold" was immersion and the "hard gold" was the plated. But I agree with Dave F., Chris, what's going on? Russ
Electronics Forum | Thu Dec 29 03:57:16 EST 2005 | sparrow
Hello Chris, To be honest, it's hard to believe you could not bond to ENIG at all. Yes, the gold layer is thin and hard, but it just narrows the process window and does not make the bonding impossible. I say this, because we have been using TS gold w
Electronics Forum | Wed Dec 28 21:18:12 EST 2005 | davef
You don't TS bond gold wire to nickel [of ENIG] for the same reason that you don't TS bond gold wire to hard gold. [Nickel or maybe cobalt is used to harden soft gold.] Together nickel and gold produce unreliable bonds. Look here: * http://www.smta.
Electronics Forum | Wed Jun 29 16:25:51 EDT 2005 | mattkehoe
When discussing this with the customer he said that his vendor recommended a hard gold plating finish on the board due to the BGA. I said "hard gold"??? And he said yes, hard gold. Turns out the boards were plated with hard gold, not ENIG. Thank
