Electronics Forum | Wed Oct 22 12:13:18 EDT 2008 | brismittr
A no-clean paste with an above average amount of halides should do the trick. Kester EP256HA is a good choice for this application if you are using a leaded alloy (Sn63 or Sn62).
Electronics Forum | Wed Dec 04 12:42:04 EST 2019 | dunks
We currently use Kester's ep256 as well and it seems to be a bit more grainy than one would expect from lead, especially if the temperature is too low. That paste says it's specialty is being robust over a wide range of profiles and stencil conditio
Electronics Forum | Tue Dec 17 14:11:43 EST 2019 | kylehunter
Haven't run those boards again, so haven't had the issue.. Since it seems like we may want to start using more aggressive flux based paste soon, what are some good choices? Ideally I'd like to stay with Kester, since they are readily available. EP2
| 1 |
winsouce.jpg)
