Electronics Forum | Wed May 29 04:34:36 EDT 2002 | Nell
Hi, Does anyone know about the epoxy push test specifications for the SMT chips component. For example: 0603, 0402 and 0201 chips. As usual, your help is very much appreciated. Thanks in advance, Nell
Electronics Forum | Wed May 29 10:14:04 EDT 2002 | Hussman69
You mean the destructive test were you continually push on a part until it breaks free from the board and flies across the room?
Electronics Forum | Wed May 29 21:56:47 EDT 2002 | davef
We have talked about testing the cure of glue, epoxy holding secondary side compomponents in place prior to wave soldering several times here on SMTnet. Search the fine SMTnet Archives, if that's what you're seeking.
Electronics Forum | Thu May 30 11:19:29 EDT 2002 | Hussman69
Ooops, my bad. "Curse your eyes Nell, for even asking a question on this forum. Check the archives before we put a curse on your adhesive process and force you to ask another question!" Whew, hope that made up for my mistake.
Electronics Forum | Thu May 30 14:11:24 EDT 2002 | Hussman69
Sorry Nutty. But then again, this coming from a guy who used to answer in Ebonics, makes me wonder why.
Electronics Forum | Fri Mar 30 13:06:50 EST 2001 | aortiz
Hi, I need support on the method or applicable standard to measure the shear force strength on chip capacitors and resistors. I know the soldered joints strength is related to land desing, solder volume, pcb and component solderability, component
Electronics Forum | Thu May 30 14:07:22 EDT 2002 | davef
Slappy The level of rightous indignation is well done, but sarcasm seems a bit overdone. Just a twinge of it would have been fine. Needs some work. Good shot at it though. Yano, maybe the 'cursing of eyes' bit was a little over the top also. Po
Electronics Forum | Fri Oct 05 16:05:58 EDT 2001 | seand
Hello everyone, Your chief variable here is going to be your epoxy. Different materials react accordingly to various inspection methods but, DEPENDING on your print parameters and material, you may be able to utilize an inline inspection machine.
Electronics Forum | Wed Mar 03 14:16:59 EST 2010 | davef
First, we expect that your equipment supplier would help you with this. Then again with lots of used equipment flying around, some of the basic stuff often gets pushed to the back of the bus. Second, here is a clip and paste on the basics of equipm
Electronics Forum | Thu Aug 30 21:57:26 EDT 2001 | Franky
I have problem about glue printing measurement ,anybody has process of glue printing . How do you measure? as I know "push test" is the method for testing the strength of connection of component and board but I don't have specification of testing for