Electronics Forum | Tue Jul 16 12:43:01 EDT 2013 | ericrr
I wonder how to solve Error E4032 Transmission error.
Electronics Forum | Thu Jul 25 23:54:53 EDT 2013 | Robin
Hi, Please share the detail input like machine model, & when the error appears. Regards, Robin
Electronics Forum | Mon Apr 09 07:48:58 EDT 2007 | realchunks
Hi Chris, So you run eror free for 2 years, then change stencil aps and get problems. Why would you go smaller? Try using your old stencil with your no-lead.
Electronics Forum | Tue Nov 15 22:08:58 EST 2011 | nevercry14
Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.
Electronics Forum | Mon Aug 19 16:42:07 EDT 2013 | thanh567
W- HTLM-5 :Hydra tool length wrong for tool tube 3. expected tool length 4.5mm, tool length found -1.358mm any one out there know what to look for this issue? sensor?
Electronics Forum | Sun Jul 28 23:11:52 EDT 2002 | caldon
Sam - If I owned Cal Driscoll Electronics and were looking for a rework system a few things I would consider: 1) Convection is key (IR as an under heater or pre heat is ok but not as the main heat source). 2)programming simple? User Friendly and easy
Electronics Forum | Sun Mar 09 18:33:04 EST 2003 | Dean
Tact time is a poor measure of your throughput capability. The Number of boards produced per hour or shift or 24 hour period is the true measure of what you are really doing. Your theoretial "tact time" can be used as a metric to judge performance,
Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback
We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making
Electronics Forum | Thu Sep 16 21:22:39 EDT 2004 | Darby
Cesar, I am not familiar with these machines but I have found that servo controller problems do not usually cause mis-placement. They tend to just stop the machine with *axis system erors. As I understand it, after you have done a return to origin,
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the
| 1 |
