Electronics Forum | Mon Aug 10 16:05:41 EDT 2020 | jmelson
Nope, can't do that, I get : Element NAME is undefined in QMART. and a whole page of debug info. I did fill in all the required fields. I was trying to post it in the parts and supplies forum.
Electronics Forum | Tue Aug 11 22:30:13 EDT 2020 | kumarb
Jon, please contact Elissa directly to discuss the details. She is a key and repeat supplier to our company for our SMT equipment and supplies. Do note that this is a used motor. Perhaps one of the other contacts above can source a new motor. On th
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Tue Jul 18 15:16:40 EDT 2017 | robertbronx
Showing on screen this message: MIPR2: Fatal Error. Reloading Motor Controller M First time I connect and only have this message on screen. The manual only says; 1) SOFTWARE PROBLEM IN THE MOT-M SERVO PROGRAM. 2) THE MOT-M OR MI board is broken. Plea
Electronics Forum | Fri Jul 21 08:42:16 EDT 2017 | davef
Try: Mycronic Inc, 320 Newburyport Turnpike, Rowley MA 01969-2002; T: +1 978 948 6919 F: +1 978 948 6915
Electronics Forum | Fri Jul 21 09:45:35 EDT 2017 | robertbronx
Hi, Dave Good morning, thank you for reply and the info. I find out the problem was an UNCONNECTED PLUG on the Power Supply unit. Which was probably caused when it was packed and shipped. Again, Thank you!! Regards
Electronics Forum | Fri Jan 06 09:39:35 EST 2023 | micropak
In newer machines, after changing a motor you have to do an "Axis Home Calibration". Once I changed Z-Axis belt on an SM-482 and it refused to successfully do "Axis Home Calibration. Then the solution was to remove the belt, rotate the motor pulley a
Electronics Forum | Thu Jan 19 08:11:27 EST 2023 | eurolan
Hello, Do you have information about the part number (if any) and/or where we could buy one? Thanks!
Electronics Forum | Fri Oct 28 04:14:18 EDT 2011 | kenmar
I have a loud humming noise coming from my MY12 X-Motor ( Like when a motor is not locked in and it hunts). This noise is not all the time but only sometimes especially with fine placement!! What can it be? I do not want to change the Motor to find o