Electronics Forum | Tue Jun 26 09:17:18 EDT 2007 | swag
You might try inspecting the drive belts in the head for missing teeth or other damage.
Electronics Forum | Tue Jun 26 08:47:09 EDT 2007 | geb
Hi we have a Universal GSM 1 flex head machine. It keeps on bringing up an "Axis Head 1 Z velocity over speed error during move absolute command". Pushing the e-stop button and then start again will allow it to continue making the panel. It happens r
Electronics Forum | Wed Jun 27 12:27:46 EDT 2007 | jaimebc
Same error here with our GSM1. Does your GSM have 2 heads? If so, this is how I fixed it. I didn't have a spare Z motor, so I swapped the Z motor for the front head with the rear head. Problem gone. Now since we don't use the rear head as much as we
Electronics Forum | Wed Jun 27 13:44:59 EDT 2007 | mika
Hi GEB, is this a similar problem that you had in the past? http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=11260&#Message46667
Electronics Forum | Wed Jun 27 02:24:28 EDT 2007 | jola
Check the drive belt first for missing tooth or bad tension. If thats ok you might need to change the clutches, they need to be changed every second year or soo. If they are worn out the wire driving the spindle might slip causing this problem. This
Electronics Forum | Sun Jan 23 00:57:23 EST 2011 | bvdb
Hi Jerry, Happy New Year. Thanks for your suggestions. You were on the right track because I remembered that one of the last things that happened before the error message started showing up was that I cut and removed the empty tape from the back o
Electronics Forum | Wed Jan 19 13:30:37 EST 2011 | bvdb
The user manual says: Cause: A stick feeder part shuttle is in the advanced position where it could interfere with the nozzle. Remedy: Press the [I/O] function key and retract the part shuttle. I don't have a stick feeder. I tried resetting the I
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Fri Feb 25 13:48:50 EST 2022 | quartermeter
I get this error on a new program. old programs work fine till I put this connector in the program. I've redone every part and still get this error. When I change the height on anything the Z =xxxx gets less or more. Thanks Jim
.gif)
