Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Sun Nov 13 14:20:23 EST 2022 | crystalw4280
Thank you. I will definitely remember this for next time.
Electronics Forum | Mon Sep 20 15:32:27 EDT 2010 | naveed
Yes!tahnkx I made a backup disc.the all data for production files,and also the data base library(vision files for component and fiducials) has been copied to the disc.we are in contact with yamaha consultant,they sent us the new manual which has the
Electronics Forum | Mon Dec 06 20:58:34 EST 2021 | erici
Hi victor, The power supply of the machine is giving us problems now, and so i cannot access anything at the moment. While working on the machine, the power on the machine suddenly started flickering and was causing the pc to shutdown as well. Have
Electronics Forum | Thu Jan 12 20:54:30 EST 2023 | cbeneat
When I see that on ours, I take the nozzle off and clean the tip. Any build up and the machine throws that error. Do a set check on the head and then look at the image of the nozzle in question...OR we hit resume and the machine ignores it until the
Electronics Forum | Tue Aug 04 12:11:56 EDT 2015 | bnorton
OS/2 UIC version 3.2.3 Powerup seems to go OK until, while the GUI says ...initializing..., an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want t
Electronics Forum | Mon Jun 12 11:04:20 EDT 2017 | bobpan
So what your telling me is kind of vague. Does the machine home and go to the front left corner of the machine? If it does....this could be a quad align problem....meaning dirt on the lens or so-forth. You should watch the heads homing in the z-axi
Electronics Forum | Thu Aug 06 20:08:35 EDT 2015 | edwaterfall01
It could be a blown fuse on the power distribution panel or a failed power supply. Check the power distribution board in the front lower center of the machine. There are 11 LEDs on the board and 10 should be ON
Electronics Forum | Mon Nov 29 20:15:22 EST 2021 | erici
Thanks for the message. Yeah the machine was about to start-up when the problem happens. I will try your suggestions. Thanks again.
Electronics Forum | Mon Jun 13 19:07:57 EDT 2005 | bobpan
Mike, Right down all the settings you have for your machine (this may take a while). Also back up the programs you want to save. Now....if i can remember correctly.....when looking into the black computer box from the back of the machine...in your bo
.gif)
winsouce.jpg)
