Electronics Forum | Sun Jul 23 22:01:15 EDT 2006 | smtek_cc
My friend just purchased a MCS30 controller(A) recently, but this controller doesn't have the error code file in the system. If I can find another normal functioning MCS30 controller(B), how can I extract the error file from it(B) and what is the pr
Electronics Forum | Fri Apr 24 13:55:09 EDT 2015 | duchoang
- Clean nozzles. - Clean camera. - Adjust lighting. - Check tolerance level. Good luck.
Electronics Forum | Mon Apr 27 07:01:01 EDT 2015 | leeg
Is it failing due to Vaccuum level?
Electronics Forum | Tue Apr 28 01:09:03 EDT 2015 | leeg
Just check that the Vacuum check is on normal and not set to Special Check.
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Mon Jul 09 12:04:56 EDT 2012 | btipcb
After fooling around with it, I was able to clear that error. I didn't know that I had to assign nozzels to each part, I though the feeder assignment would do that. I appreciate the reply.
Electronics Forum | Fri Apr 24 10:58:15 EDT 2015 | chris_jayconsystems_com
I have checked and rechecked all my dimensions on the capacitor which is a 402 size. The manual says that the center is incorrect. Need some help to figure out why it is throwing this part away seeing it passes a vision test. Any help would be gratef
Electronics Forum | Sat Jul 07 11:45:26 EDT 2012 | btipcb
I purchased and am setting up a used QSA30. It has been a little frustrating but I finally have an almost program. The isse is that I can not generate a placement program because it says that the ANC is not registered. I can look at it on the sy
Electronics Forum | Wed Dec 14 15:49:30 EST 2005 | derengmao
I did calibration for the fixed camera according to the Training Center System's book. But it seemed it is for diciding the heads'offset, very few is for camera itself. When calibrate, It does recognize the calibration tool ad finish. However when te
Electronics Forum | Wed Jun 29 08:48:39 EDT 2005 | jdengler
The MCS30 maintenance manual has a procedure near the back on exactly what to do for this error. Jerry
.gif)
winsouce.jpg)