Electronics Forum | Sat Feb 21 11:07:39 EST 2015 | jfuess
Hello all, I have recenetly come into possesion of a used Hotflow 5 oven and I'm trying to get it running. Unfortunatly the LCD/Keypad has been damaged and although it still works, some of the buttons don't function and the LCD has lines through i
Electronics Forum | Thu Sep 04 02:43:09 EDT 2008 | benefon
Thanks This error only occurred with one oven profile with the reflow zone temperature set at 270�C. Perhaps it really has to do with the exhaust pull as the oven is operating very near its temperature limit with this profile. I will check that. Tha
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Tue Aug 24 03:36:19 EDT 2010 | naveed
Hi all!i m using yv100xg line,with vois application version 1.5R2000,when the mechine starts,after loading all files and returning to origin,a mesg appears ,that iz"Ea12324:the repair detection of the file.the mchne is unusually finished and it has t
Electronics Forum | Fri Apr 27 09:05:51 EDT 2018 | dszewczak
prompt) When we came back in the morning it was repeat scrolling an "ODD ADDRESS ERROR" on the monitor. I used a loopback to verify that the serial connections were good all the way to the control box. We tried uploading the main program to the ma
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Thu Aug 29 05:01:38 EDT 2013 | bobpan
Motor Error 5 is usually an interlock error. Take off the rear right cover and look at the red and green led's on the driver cards. If they are both lit....you have a door open or if you have carts....a feeder base switch is up. Good Luck
Electronics Forum | Fri Aug 30 10:35:54 EDT 2013 | nophsem
Data base Utilities --> Download MOD Codes to assembler) and the motor error # 5 appeared instantly in the handheld.
Electronics Forum | Fri Sep 26 07:43:55 EDT 2008 | mysmt
Hello aj, 5V & 12 V checked & present.
.gif)
