Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Tue Dec 25 17:15:11 EST 2018 | bane016
Did you reslove your problem?i didnt have this problem on my machine....but im wondering to know what is problem...mby you turn nozzle on wrong side and machine no see 2d code..
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Wed Sep 19 16:20:46 EDT 2007 | highspeed
Can anybody tell me what an error code 6 means after a GSM Calibration.
Electronics Forum | Tue Oct 20 23:14:01 EDT 2015 | kiwiguy12345
Hi, I have struck a problem with the X axis on my Juki 740. As soon as I "home" the machine the X driver displays the code "961" Does anyone have any ideas as to a solution for this problem? Thanks!
Electronics Forum | Wed Mar 20 15:01:37 EDT 2024 | linux
Reboot usually does the trick, Reason for these fault, (1) Nozzle holder, the grippers are holding the nozzle too tight, stretch the spring slightly, (2) shaft is sticking, removed the head lubricate the shaft.(3) Nest not opening and closed within t
Electronics Forum | Fri Mar 02 14:00:39 EST 2018 | magergar
I have a problem with my fuji machine, it was working and then this error code appear: INTL SRV creation error Error Code:12037A20 and this shows every time on boot and doesn't let me do anything. what should I check?
Electronics Forum | Tue Sep 17 05:19:48 EDT 2013 | engineering@smtxtra.com
Hello, its simple the Panasonic tape is encoded, the non original splice tape you try to replace is not coded hence error on feeder sensor. we offer Panasonic replacement splice tape, for a sample please contact the office, hope this helps Robi SmtXt
Electronics Forum | Mon Jul 08 11:19:55 EDT 2019 | jwwolf
How can I get past error codes upon startup of a Panasonic BM221? There is a password required and this machine was acquired from an auction. Are there default passwords, or is there a way to reset the machine? Thanks
Electronics Forum | Wed May 18 12:20:27 EDT 2005 | Tech
We have a panasonic MSR and keep getting collation errors and not sure how to remedy without shuttingdown machine and starting over. Any suggestions would help? Thanks.