Electronics Forum | Wed Jun 21 12:31:42 EDT 2006 | Rob
Hi Grant, You forgot Charlatan, or my particular favourite: twat. Tube feeders also encourage operator error, where tubes being changed over all of the time can be put in upside down.
Electronics Forum | Mon Jan 19 14:00:34 EST 2009 | jwolvans
Thank you for the customer's perspective, Alien. We actually send a short "wish-list" to our customers and includes such necessities as: 1. BOM. Must be Rev-controlled and contain, at minimum, a useable part numbering scheme, adequate description fi
Electronics Forum | Thu Nov 25 03:38:28 EST 2021 | ravikumargv
Hi, For above highlighted issues has been solved and now started "wrong embedded real time code version fatal error -reinitialse machine" what is the issues and where it went wrong please advise me to check further
Electronics Forum | Tue Sep 17 05:19:48 EDT 2013 | engineering@smtxtra.com
Hello, its simple the Panasonic tape is encoded, the non original splice tape you try to replace is not coded hence error on feeder sensor. we offer Panasonic replacement splice tape, for a sample please contact the office, hope this helps Robi SmtXt
Electronics Forum | Wed May 27 16:39:33 EDT 2009 | rmitchell
Hi, I think vision 20 will work as well. If not we have used 100 or 105. Have you tried placing the part with the machine trace on? If so is it finding all the leads? any error codes? If you are defining the leads in the EL lead data I would not d
Electronics Forum | Thu Mar 20 11:30:58 EDT 2014 | dave222
Hello Again. I little more information about the issue: when trying to zero machine head the spindles move up and down about 6 times before giving the error code. also I notice that all the LEDs on the circuit board are off. L11 - L18. and the nume
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Sat Jan 20 17:41:11 EST 2007 | bvdb
Hoping someone can help us. Our Fuji IP-1 won't boot up unless we disconnect the 25 pin RS232 connector that runs to the MCS16/F programming computer. It doesn't matter if the 9 pin connector on the other end of the cable is plugged into the MCS16/
| 1 |
