Electronics Forum | Tue Sep 01 06:15:09 EDT 2020 | bukas
do you get error when software loads or when you run program? once i had MPU stop because there was skipped array in my step file
Electronics Forum | Mon Aug 31 07:06:20 EDT 2020 | bukas
did you try to unslot all computer boards (both PC and machine)and put them back? sometimes they loose contact and make wacky errors...
Electronics Forum | Wed Feb 23 13:50:55 EST 2005 | c.b
I am currently using a quad 1000, and up to now it has been a good reliable machine upto yesterday. I now have an error message that reads "driver error, emergency stop" the machine then freezea and will not run. Could some one please tell me if t
Electronics Forum | Fri Sep 04 11:36:42 EDT 2020 | inspiredmorris20
!!UPDATE!! We have found the issue, power supply #3 was bad. The PSU was not sending 24v to the emergency system which is normally a closed circuit. Being that the emergency system was not getting the 24v it assumed the e-stop had been depressed. T
Electronics Forum | Fri Sep 04 13:25:25 EDT 2020 | bukas
great to hear you solved it :)
Electronics Forum | Mon Aug 31 12:01:14 EDT 2020 | inspiredmorris20
Thank you bukas, I have not tried to unslot the computer boards. Are you referring to unplug the hardware connections to each circuit board and reconnect them? Thanks again for the reply!!!
Electronics Forum | Mon Aug 31 13:31:09 EDT 2020 | bukas
when something like this happens I usually do a connector and PCB slot cleaning. apply contact cleaner and plug/unplug (slot/unslot) connector (PCB) few times then blow it out dry. do it for each PCB and connector.
Electronics Forum | Tue Sep 01 01:32:38 EDT 2020 | jmelson
Oh, well, there's your problem! Either there's a short or the power supplies have gone bad. Jon
Electronics Forum | Tue Sep 01 11:53:21 EDT 2020 | inspiredmorris20
bukas, Yes, as soon as the software loads it immediately throws a 0002 (front E-stop pressed) and will not come out of EMER mode until i stop, reset, ready, on the control panel. yesterday however it also threw a E100 I/O I/F board communication d
Electronics Forum | Mon Aug 31 19:53:17 EDT 2020 | inspiredmorris20
thank you both, We removed the connections and cleaned them. unfortunately no success, we are testing the conveyor interface board to see if we have a bad board. additionally we found that power supply #3 and #4 do have 110v going in but do not have
winsouce.jpg)
