Electronics Forum | Sun Oct 12 22:08:34 EDT 2014 | cusackmusic
I just got a used AP/C which I guess is also called an AP25? After fixing a few obvious issues, I powered it up, and get a hardware limit error. I have verified that none of the axis are near their limits. Without a manual, I'm not sure where to go
Electronics Forum | Mon Oct 20 15:28:22 EDT 2014 | island2013
We've got a set of manuals here for the AP series. If you would like to borrow them email me.
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Mon Apr 11 06:54:03 EDT 2011 | mosborne1
Wipe off your linear scales and clean your quadalign lense.
Electronics Forum | Mon Apr 11 15:57:25 EDT 2011 | bobpan
If the feeders that you are having problems with have tall parts in them.....and these are the ones the machine is stopping on.....check to see that you are not scanning higher than what your function 30 nozzle height is. In other words...if your fun
