Electronics Forum | Wed Mar 21 09:33:05 EDT 2007 | chrisgriffin
Every time I had a disk utility take that long, the hard drive was pretty much not usable. Could be write errors or bad sectors on the drive.
Electronics Forum | Mon Feb 28 14:01:03 EST 2000 | greg
I have the following problem with a GSM. When powered up I get the error "Error Initializing Hard Disk Controller 0" do you think this is the controller if so what is the part number for a controller.. any input would be great thank you
Electronics Forum | Mon Feb 28 14:01:03 EST 2000 | greg
I have the following problem with a GSM. When powered up I get the error "Error Initializing Hard Disk Controller 0" do you think this is the controller if so what is the part number for a controller.. any input would be great thank you
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Thu Aug 14 13:49:26 EDT 2014 | dyoungquist
Motor control MSETDYN -> Initiate axis C -> Centering jaws 156 -> Motor timeout Did not reach specified position Hardware problem Looks like you have something wrong with the movement of your centering jaws.
Electronics Forum | Mon May 16 17:58:54 EDT 2005 | ??
Are you sure you dont mean quad 100. The software for a quad 1000 (which was a samsung machine) was not available on disks or to install......I dont recall ever seeing it on a disk. If its a quad 100, you would need version cc5.6d central controller
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
