Electronics Forum | Wed Aug 26 17:06:56 EDT 2009 | andoe
when i transmitt data to the cp6 every thing seems to go okay until the end and i get a -- "A21E transmission error". i have checked the cable (i can program my IP3) any ideas? thanks ron
Electronics Forum | Wed Aug 22 15:48:03 EDT 2012 | rmitchell
Hi, Our CP8 is down with this message. Parameter: EMG FjMcEmgservoEnable CAM(0),FjlSrvAxis Reset R=304087143 The machine error also has possible broken wire. None of the servo amps show an error they are all (bb) on the led read out We do not hav
Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Mon May 31 09:47:57 EDT 2021 | fujipro
Sorry, no chance to check the IPS on AHC without the necessary Jigs and the knowledge. 7F12 is typical errorcode for a poorly connected Ribbon cable on the LED Board. If this error still occurs after reconnected the LED Board is may broken. If needed
Electronics Forum | Mon May 09 17:49:28 EDT 2005 | chon
Inspect the cables specially in those area where cables have bendings with the motor motion. If they have something covering them or extra insulation try to remove it and inspect closely. If the machine runs and suddenly stops with this error and aft
Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Mon Mar 09 13:07:52 EDT 2009 | rodrigo
Hi all, Our IP-2 stop working during production with a Servo NG error. Turning it on and off just goes back to the same thing or "Turn servo power on" error message. I was checking the power for the servo amps and I found a 35VAC line that is missin
Electronics Forum | Thu Dec 03 17:56:59 EST 2020 | ravikumargv
Hi, Ip and mc host both pinging and no issues, but still sitest given communication error, for this i replaced communication card and lan cable as well. But machine software not booting at all... Regards, Ragav
Electronics Forum | Tue Mar 10 14:11:42 EDT 2009 | rodrigo
Ok I checked and here are the results... Z1 11CS3x Green LED on Q1 11cs4x Green LED on Z2 12cs3x Green LED off (This is the relay I mentioned in my original post). Q2 12cs4x Green LED on M1CR4x Green LED off The servopack SA-6 is the one with the
winsouce.jpg)
