Electronics Forum | Tue May 30 08:14:34 EDT 2000 | Aerin Bryson
I had a problem accessing my mail for along time, however, that is resolved now. Now I am having trouble sending email - I sent a test message to an internal smtnet recipient and one to an external recipient and both went OK. Other than that I have
Electronics Forum | Tue May 30 09:53:43 EDT 2000 | Neil Peaslee
Right now we are using a custom built web email solution to provide SMTnet web email. Unfortunately the service agreement recently expired and I have to keep a fairly close eye on it to make sure that it is running. Within the next few weeks we will
Electronics Forum | Fri Feb 24 20:05:31 EST 2006 | Robert
I had a problem to calibrate the vision of the DEK 265LT machine. After touch the calibration vision button a error message come up "Unable to load file CALIBRA.PR1" Does anyone know what fault could cause this? Do i need a calibration program? Doe
Electronics Forum | Tue Oct 26 00:03:09 EDT 2010 | jmelson
Hmm, that's a fairly old machine, even older than mine! (I have a CSM84 PA130640). Anyway, it is best to program the machine from CAD system data, I wrote a little program in C to read in the component type and XYR position, and produce the file in
Electronics Forum | Fri Feb 12 19:40:42 EST 2010 | rodrigo
I posted the message below on Friday and today Monday I started looking at the problem again. We have a computer with a setup that works. It is the original PC we bought with the F4G but it is set up for a machine we do now have ,IP3. I was looking a
Electronics Forum | Wed Aug 04 23:32:05 EDT 2021 | tey422
Seem like sensor failed to detect the tool is fetched. You might want to try to clean the inside barrel of the fetch tool. Use the foam swab, to clean it. If it's a spring loaded tool that you trying to install, you have to make sure the top of the
| 1 |
