Electronics Forum | Wed Jan 29 18:41:22 EST 2014 | alphatronique
Hi did you look for mechanical issue like friction somewhere ? when init i use very low force buy much more while running that may explain wly machine work in production fur fail only on init i face that whit flex cable that make just little fr
Electronics Forum | Tue Jan 05 21:24:34 EST 2021 | rmitchell
We use to have to replace the "dog" tube when it got rounded out or worn a little. If you you already cleaned it and can see the red light going off and on when you gently push up on the nozzle it is just not seeing in time and it gives the nozzle c
Electronics Forum | Tue Jan 05 17:12:20 EST 2021 | greezmky
Before our holiday shutdown an experienced party came in and showed me the PAM process on the IP-3. We made some adjustments, and all was well. Yesterday I found that we may have accidentally mixed up some nozzles, so I verified where each should go
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Mon May 16 11:45:35 EDT 2005 | PWH
Agree with PDE. We have two GSM's and we get this error often. Palm down e-stop when you get this error message. Machine will drop nozzle bank down after doing some segment repairs. Open covers and make sure nozzles are seated in reference to ali
Electronics Forum | Fri Jul 14 17:32:36 EDT 2023 | ttheis
Having an issue with changing nozzles on one of our FJ3 heads. We get errors on spindle 5 and 6 when bank-changing nozzles. Event code 31208, unable to find any info on this code. When we use the put nozzles away routine it does it no problem but has
Electronics Forum | Wed Jan 06 11:05:13 EST 2021 | greezmky
Thank you rtmitchell, being unfamiliar with the system, I missed that the end is slightly nicked. I pulled a dog out of a machine that has been cannibalized, I verified that it was straight and not nicked, and installed it in our production line mach
Electronics Forum | Thu May 03 22:51:14 EDT 2007 | jmelson
I am still learning the CSM84, but have gotten one board programmed and working. Now, I'm doing the next board, and need to use the mechanical alignment unit for a 22 x 22 mm TQFP. This chip is too large to clear the jaws on any head. Can the CSM h
Electronics Forum | Mon Sep 13 21:18:29 EDT 1999 | Dave F
| Hi, | | Recently encountered missing components problem at the SMT process. | Among 13 chip components from the same part number mounted on the board, only 4 ( located in a same row and next to each other) were missing after post reflow. Checked t
