Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Wed Jun 10 00:34:40 EDT 2015 | vinitverma
I understand from your post that the head does go to the nozzle changer intending to change the nozzle but sometimes it entirely fails to pick up the nozzle and sometimes the nozzle gets picked up a bit but gets stuck in the nozzle changer. This mos
Electronics Forum | Tue Jun 09 04:49:12 EDT 2015 | vinitverma
Is the machine not picking up nozzle from the nozzle changer or is the head 7 not picking up any components? Or is the mis-pick rate too high?
Electronics Forum | Tue Jun 09 09:04:58 EDT 2015 | lisaaci
Its not picking up the nozzle from the changer. It either doesn't at all, or leaves the nozzle partially in the changer.
Electronics Forum | Tue May 12 17:01:27 EDT 2015 | lisaaci
Our Philips Topaz is not picking up any nozzles on head 7, or only partially picking it up. Previously, the machine had thrown up a message that head/nozzle 7 needed cleaning, but that message doesn't appear anymore. I don't know if the head needs cl
Electronics Forum | Wed Jun 10 01:33:20 EDT 2015 | leeg
Are the leaf springs in good order and set right? If they are then it could be calibration related.
Electronics Forum | Wed Jun 10 01:35:07 EDT 2015 | leeg
Does head 7 calibrate ok? Is it a bent shaft?
Electronics Forum | Fri Feb 03 17:57:40 EST 2017 | sarason
Is it the weight of the component versus nozzle size and vacuum pressure? sarason
Electronics Forum | Fri Feb 03 10:34:09 EST 2017 | prdmm1
PANASONIC ERJ-12ZYJ203U i am having a lot of problems picking this resistor up. i have purchased a new tool per engineering (NOT the problem). it seems the my9 is picking up then dropping it. then the machine goes to pick another and picks the dropp
Electronics Forum | Wed May 25 13:02:57 EDT 2005 | jsloot
I have two Samsung machines running about 500 hours a month each. Placement rate is on the average 12,000 CPH between the two. The life expectancy of the nozzles used on 1206 packages seems rather short to me. It was about 2 months ago I replaced the
