Electronics Forum | Thu Mar 15 18:15:28 EDT 2018 | maustin
The 740 has been a great machine for us. We've been able to reliably load components as small as 0603 (we've not tried 0402, but I believe with a special nozzle adaptor, you can get it to work) and place a 7x7 56 pin QFN with 0.4mm pin pitch with hi
Electronics Forum | Thu Aug 26 13:20:56 EDT 2004 | pjc
Machine design plays a major factor in actual placement rate vs. the published tact time max speed. For example, random access horizontal turret head machines can vary greatly depending on nr. of different components and size ranges, while the dual g
Electronics Forum | Tue Nov 13 11:14:15 EST 2012 | jaimebc
For the past few weeks we have experienced an intermitent midas theta error.During normal production the machine times out while just after picking up a component waiting for the theta to center it.Sometimes it fails to leave a tool. Reinitianing the
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Tue Mar 09 22:47:26 EST 2004 | pdeuel
Contact sensors out of adjustment. If you push up on spindle the led should change state. same if spindle is pulled down. I have also had problems with PTIF error during zeroing Soft stop. last messages recieved were reported as z axis time out durin
Electronics Forum | Tue Sep 12 14:35:41 EDT 2017 | deanm
In trying to have things run smoothly with placement, I have to do a lot of theta adjustment to get the rotation right during placement. Even if the part looks good on the PnP machine screen sometimes it places differently than what is shown. If I u
Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
Electronics Forum | Wed Apr 07 21:49:44 EDT 2004 | Ken
My favorite kind of calibration is where the machine learns what it did incorrectly. Then fixes itself! However, there are many types of machines that rely on human feedback as to the results of what it did. nozzle calibrations involve many factors
