Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Mon Oct 12 01:20:42 EDT 2020 | azdback
LandrySMT, after monitoring the errors and considering what we replaced, I also decided to replace the Z hydra motor and encoder. That fixed our problem. I looked at your message and I agreed that the next step was to replace this part. We ran hi
Electronics Forum | Wed Jun 24 16:10:09 EDT 2020 | landrysmt
Hello, Finaly, What was the problem on your Hydra head? Maybe my message comes too late, but my answer might help ... It could be linked to a problem with the Hydra Z motor / encoder. In certain circumstances, the Hydra Z axis is not in the correct
Electronics Forum | Wed Mar 20 14:05:29 EDT 2019 | alexcouto
Hello again, I put the motors 1 and 6 back in their correct positions, but head 1 now gives me a new error. will it be necessary to configure the head 1 motor in any way? I was still checking to see if the belt and the engine would be in position, bu
Electronics Forum | Thu Mar 21 02:52:59 EDT 2019 | bukas
looks like home sensor problem, whats the error message? does head 6 now work properly?
Electronics Forum | Fri Mar 22 03:19:43 EDT 2019 | bukas
well, in video shown it looks like #1 motor drives head #1 upwards but does not detect home sensor being triggered. and then you get timeout error, head not being able to reach the position ( machine not registering it has reached position). since yo
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Thu Sep 23 11:37:43 EDT 2010 | flipit
I had 4 of these machines. They are good machines but I have seen this error often. Is the problem only on one head L or R? If so swap electronics L to R and see if it follows. You can even swap the Y motors. The items that could cause this prob
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback
We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making
