Electronics Forum | Tue Jun 04 19:33:16 EDT 2002 | rob_thomas
Dave's estimation is pretty conservative but there is a lot of equipment out there and a lot of people happy to make a sale.Implementing both mentioned processes it's difficult and time consuming .Even if you get good training from whoever sells you
Electronics Forum | Mon Sep 17 16:03:13 EDT 2001 | jschake
The results from an experiment comparing 27 different combinations of pad dimensions concluded that the pad design with 15 mil pad length, 12 mil pad width, and 9 mil pad separation produced the best assembly yields. A 5 mil thick laser cut stencil
Electronics Forum | Thu Sep 11 16:50:18 EDT 2003 | davef
Sure it's conceivable that thin HASL can cause tombstoning. Harkening back to the ample discussion in the fine SMTnet Archives, tombstoning is caused by an imbalance in solder surface tension between the two pads of SMT component. The source of thi
Electronics Forum | Fri Mar 27 12:46:23 EDT 2020 | unisoft
Unisoft has been import gerber only for years to setup assembly, aoi machines, etc. *** Help for Importing GERBER only files for used in programming Assembly, AOI, Test, Selective Soldering machines (X/Y Center, Rot, Part#). Also allows you to cre
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Tue Mar 04 16:50:56 EST 2003 | msivigny
Hello Rohan, this is starting to date nearly 6 years ago but I will remember everything I can, we used a custom interface to input data and everything was stored in a very large database on a specific server only for quality data, I think we used Ora
Electronics Forum | Mon Sep 21 04:23:16 EDT 2009 | smtbox
R series Features FCS (Flex Calibration System) highly regarded easy maintenance just got even easier! The optional FCS calibration jig is a simple to use system to re-calibrate placement accuracy. The machine automatically picks and places jig comp
Electronics Forum | Sat Jun 06 09:53:59 EDT 1998 | Earl Moon
GEOMETRIC DIMENSIONING AND TOLERANCING (GDT) Using and applying GDT to printed circuitry and assemblies is very much like applying it to any other design for manufacturing (DFM) or design for assembly (DFA) requirement using concurrent engineering (C
Electronics Forum | Mon Mar 03 13:18:02 EST 2003 | msivigny
Hello phil, The use of AOI systems give us the opportunity to auto-collect defect information much the way you're using them now. AOI systems become extremely effective when the collected data is used to perform some positive change into the process.
Electronics Forum | Wed Feb 18 12:42:43 EST 2004 | babe
OK, if the sphere of the ball and the paste on the pad are both eutectic, 63/37 then the paste will reflow first causing a drop of the component, after which the spheres will reflow causing a double drop and a good intermettalic. You can see this by