Electronics Forum | Tue Aug 22 03:04:07 EDT 2006 | PP
Any help/suggestion is much appreciated I am doing lots of BGA Reworks from a small uBGA with a few balls to a large BGA with over 1500 balls. The reworks have been done on SRT 1100 Series Machine for many years. SRT 1100 Machine is good for the c
Electronics Forum | Fri Aug 27 10:25:52 EDT 1999 | Matthew Park
Is it feasible to have one type of board carriers to take boards thru 1) glue curing process for first side and 2)invert carriers with boards, and 3)reflowing second side, and 4) do manual stuffing of th components and 5) take them thru selective wav
Electronics Forum | Mon Jan 15 13:12:18 EST 2007 | realchunks
So others can solder the same board and part but you can't. Dipping the legs in flux doesn't help. Then it's either your pre-heat or wave. Measure your pre-heat and compare to others or flux mfger. Do you have chip wave or something like an Omega
Electronics Forum | Mon Dec 22 12:27:41 EST 2008 | evtimov
What I know for SN100 - it is designed for selective sodering. I beleave it is more expensive, compared to other alloys. Emil
Electronics Forum | Thu Jan 27 06:39:59 EST 2005 | reash
For now, on this first board, we will be reworking components such as 0805 and 1210 size caps and resistors, along with SOT-23 and SC-70 size packages. We might eventually get into BGAs. This board will most likely be a double-sided board, probably
Electronics Forum | Mon Oct 24 16:10:07 EDT 2005 | Brian Davis, Compex Technologies
Dear Colleagues, We are looking at entry level AOI solutions. We are currently evaluating the Mirtec AOI MV-2HTL. We are also looking at Vitech because of their perceived "edge" in the industry. I know that this forum has approached this question be
Electronics Forum | Mon Jul 17 13:36:55 EDT 2006 | kjeffries
I appreciate your comments regarding the programmability of the Mirtec. What type of SMT machine do you use? How easy have you found it to transfer the SMT profiles to the Mirtec? How do you rate the Mirtec in handling top/bottom, multi-panel asse
Electronics Forum | Tue Jul 18 00:47:42 EDT 2006 | sant
Hi Few weeks back for the similar thread I was enquiring about the performance of benchtop AOI. I did see the Saki m/c.It seems to be a good m/c with different technology. I have not bought yet. Looking to have more feedback. Any opinion about Saki
Electronics Forum | Tue Jun 20 15:08:30 EDT 2017 | ranap121212
Hello I have the problem with selective soldering on the robot. Thin balls appear on the laminate. The tin sometimes shoots...? and then the balls are a few millimeters from the soldering point. I tried up or down with temperature, but it did not wor
Electronics Forum | Fri Apr 11 16:11:32 EDT 2003 | stefwitt
The question new or used was discussed several times. If you start fresh and have no experience with one or the other machine vendor, I would get a new machine, whose supplier has a service tech in driving distance. If you select the used machine pa
