Electronics Forum | Fri Jan 13 12:12:48 EST 2006 | jimk
we have 4 bottom IR heaters and a 2 zone bottom Quartz heater (2 lamps/4 lamps) and 1 convection heater above zone 1 IR. we have very tight restrictions from customer and I could send profile view to your email if possible
Electronics Forum | Wed Nov 27 13:07:07 EST 2013 | processman
Hi, Can somebody confirm the correct operation of the rear clamp rails on an Ersa Ecoselect 2.... Do they only activate when the PCB comes into the machine then release, or stay activated thru out the flusing, heating, soldering etc
Electronics Forum | Tue Dec 03 14:05:09 EST 2013 | chadsuckow
You can have it either way. In each program you can select to have the side pressure active for the entire program. The factory setting is to have it release immediately after it pushes the pcb against the fixed rail.
Electronics Forum | Thu Dec 12 12:44:45 EST 2013 | jaimebc
Just to add to Chad's response, there is box that you need to check in the program editor, ours is under the colum soldering unit one, click on the icon at the bottom, you should now be able to see a box " fix horizontal permanently". Check this box
Electronics Forum | Thu Dec 01 21:15:26 EST 2005 | davef
Try: * Caltex [www.bgascope.com] "Hirox" scope * ERSA [www.ersa.de] Ersascope
Electronics Forum | Tue Oct 21 23:28:59 EDT 2003 | xz xiao
We all know the Lead Free process is trend, so we trial run it, now it is only my comment that we have a good achievement after several tries,we have taken serveral photos about Lead Free process with ErsaScope. 1.The surface of the solder joint are
Electronics Forum | Tue Oct 21 23:29:08 EDT 2003 | xz xiao
We all know the Lead Free process is trend, so we trial run it, now it is only my comment that we have a good achievement after several tries,we have taken serveral photos about Lead Free process with ErsaScope. 1.The surface of the solder joint are
Electronics Forum | Wed Jan 05 11:43:11 EST 2000 | Dave F
Yins, In low volume applications, using X-ray for BGA mounting process control is: 1 Very expensive approach, as you've stated. 2 Requires beaucoup operator training and interpretation of results. Which is double bad, because of the intermittent n
Electronics Forum | Thu Jun 21 07:57:09 EDT 2001 | brownsj
One of the systems I saw which was very good for a low cost inspection system was the Ersascope. http://www.ersa.com. This sytems looks underneath the BGA from the side so it will detect bridges though it probably isn't very good for insufficients. I
Electronics Forum | Fri Jul 16 15:01:31 EDT 2004 | waveroom
I cant wait to hear the replies. We are an Ersascope dealer. Have sold over 25 systems. Have looked at all the competitors and Fortunately in our minds, Ersa still offers the best system. Not the least expensive, but the best. I found that ease of