Electronics Forum | Fri Dec 04 12:00:07 EST 2020 | jandon
Has anyone successfully replaced JUKI KE-2050/60RL HDD with the SSD hard drive?
Electronics Forum | Mon Nov 09 22:51:34 EST 2009 | msherwood
How hard is it to replace and reformate the C: drve in a HSP 4796. I have all the disk I think and the cal disk. Is there something specail I should know before I start.
Electronics Forum | Mon Nov 07 13:19:42 EST 2016 | travishemen
We have had some luck buying an exact matching hard drive and swapping the circuit board from the newly purchased drive to the old drive. I have done this twice in the last year and it has made the old drive work again. Travis
Electronics Forum | Sun Nov 06 16:10:25 EST 2016 | teslalab2
Hi! I have a Quad IVc pick and place that runs dos. The GUI computer is a compaq prolinea 4/33s. The hard drive went stupid mode and now wont respond. I have all of the data backed up. I tried transferring the files to a fairly modern hard drive (20g
Electronics Forum | Mon Nov 07 06:08:12 EST 2016 | bobpan
I think there are size limitations for the hard drive in those old computers. I would look on ebay and try to find an exact replacement and transfer your files onto it. I think it should work if everything is copied. good luck
Electronics Forum | Mon Nov 07 08:01:03 EST 2016 | ttheis
I have seen people use large, modern hdd's but they need to be re-sized to the limit of the hardware you are installing into which can be tricky. Also, its best to take an 'image' or clone an hdd as soon as you get equipment that is old or you suspec
Electronics Forum | Mon Nov 21 15:53:38 EST 2016 | teslalab2
Ok thanks for you help. I am up and running again. I had thought about the upgrade, but it would never pay off in my little garage operation.
Electronics Forum | Sat Nov 19 03:26:08 EST 2016 | sarason
Have you tried running your image under a Virtual machine. From this you may be able to work out the requirements of the original machine, and so have some parameters to port the image forward on a faster PC, like say a pentium or Pentium III while s
Electronics Forum | Fri Apr 03 15:42:23 EDT 2009 | rkevin
Hard to beleive anything from Kester these days would help. (Unsolicited opinion)
Electronics Forum | Sun Apr 12 21:37:52 EDT 2009 | padawanlinuxero
HI !!! We have the same oven! and yes profiling is hard, but not that bad. Check with the solder paste company for information, right out of my head dont remember for the temps that we use on mondayIcan show you my profile so that youhave an idea
