Electronics Forum | Mon Nov 01 15:47:21 EST 1999 | Jim Snipes
Dave thaanks for your quick reply. The flow through probelm exists on several component, Examples; small Tan electolic caps.,electrolic epoxy caps. and one specfic lad on a resistor network. I have veried conveyor speed and readjusted heat sett ings
Electronics Forum | Tue Dec 05 03:39:39 EST 2006 | pavel_murtishev
Good afternoon, Due to problems with power connector soldering I have to overprint paste on pads for this connector. Stencil thickness is 125um and I cannot make it thicker. Area ratio of chip resistor assemblies limits stencil thickness to 125um. R
Electronics Forum | Tue Nov 02 17:52:17 EST 1999 | Dave F
Jim: Several points: 1 If you�re correct about corrosion of your component leads (which is entirely possible if the leads are steel, as you say), then the AIM 264-5 no-clean may not be aggressive enough to remove the corrosion you are seeing routin
Electronics Forum | Fri Mar 27 10:04:51 EDT 2009 | ericthered
We have been having problems with proper wetting when running mainly lead free but also leaded solder in our Ersa Hotflow 3. Solder either often looks grainy or doesn't flow over the whole pad. This is generally the case when my profile is 170 firs
Electronics Forum | Mon Oct 14 00:05:50 EDT 2013 | felo188
Some ideas?
Electronics Forum | Tue Oct 01 14:53:24 EDT 2013 | felo188
it's means that a pcb part responsible for second top zone is broken. To make sure i changed second thermocouple and heater with first. Now there is no overshoot. But I have still problem with automatically shutdown. It is turning off after 1 or 2
Electronics Forum | Mon Dec 15 09:48:53 EST 2008 | luke555
i am using ersa ir500a. my lab room's power is very low. it always shutting down by itself. My question is, after power on, the tem go to 300'c and stay there without runing profile. any one can help me please.
Electronics Forum | Wed Dec 17 08:43:14 EST 2008 | stiva
Have seen this problem on other types of oven and it was caused by failed solid state relays that energise the heaters.
Electronics Forum | Tue Aug 02 12:41:57 EDT 2016 | max83
Does anyone know where can we buy the spare parts for Ersa hot flow in Europe? Best regards Max
Electronics Forum | Tue Oct 20 18:37:02 EDT 1998 | Jason
Does anyone use the VersaFlow system from ERSA? If so how reliable is it really? and what does the actual repeatability look like? Any maintenance problems or parts issues? ERSA almost promises 100% yield from this machine for our application. That
winsouce.jpg)