Electronics Forum | Sat Jun 24 07:23:06 EDT 2017 | tch
You will need to preheat the boards for a lead free selective solder process. A preheat module is critical for any wave or selective solder process, if you don't get the board preheated properly the solder is going to resist flowing to the top of the
Electronics Forum | Tue Nov 14 16:06:27 EST 2000 | zorox
We have an ERSA machine here where we have solder "spikes" occasionally. We have made sure our flux is dispensing properly, we have adjusted z axis speeds, our preheater is heating properly, adjusted XY speeds, etc. Can anyone think of something we m
Electronics Forum | Wed Nov 12 18:00:49 EST 2014 | davef
Look here: http://www.ersa.com/media/pdf/fachartikel/fachartikel_englisch/global_smt_selective_soldering_article_03_2013_.pdf
Electronics Forum | Fri Apr 22 11:21:42 EDT 2005 | HUH
There are several types of lasers to do laser soldering. Panasonic also has a high intensity light that can solder as well. I've tried em' all and two over whelming things stand out when it comes to this type of soldering. #1 is preheat. It seems
Electronics Forum | Fri Jun 23 15:11:11 EDT 2017 | emeto
Try add a pre-heater. If not change the process or the machine. With KISS you will hardly get any PCB to work properly.
Electronics Forum | Thu Jun 29 12:07:09 EDT 2017 | georgetruitt
HOW THICK IS THE BOARD? IS THERE A LOT OF COPPER IN THE BOARD? DOES YOUR CUSTOMERS PROVIDE HEAT RELIEF IN THE BOARDS BARREL DESIGN THERE NEEDS TO BE PLENTY OF ROOM FOR LEADFREE SOLDER TO FLOW, DID YOU CHECK YOUR PIN(LEAD)TO HOLE (BARREL) RATIO? N
Electronics Forum | Fri Nov 14 10:45:22 EST 2014 | tombstonesmt
We use both types in house. We started with a board moving over the pot, slowly moved on to Jade machines and eventually Synchrodex. Like you mentioned without palletizing you'll have component movements during the cylce and most likely won't have th
Electronics Forum | Fri Apr 22 14:28:38 EDT 2005 | Gary Goldberg - PROMATION
Low end selective laser soldering systems are limited to what types of soldering can be performed. I have read through the previous comments and find that most have commented on earlier technologies (which do not offer the features today's system do)
Electronics Forum | Thu Dec 21 15:13:16 EST 2017 | georgetruitt
Is the process the same for every product running through the selective solder machine? Load program, acquire or set up fixture, Change/load flux?, Change/Load solder pot? Are the machines cold when the operators need to use them or are the machin
Electronics Forum | Wed Dec 27 09:05:35 EST 2017 | charliedci
All the response is appreciated. We have 4 SS machines and 2 operators (normally). Some jobs take up to 15 minutes (multiple boards), some take less than 2 minutes (machine time). Some involve fixtures, preheat, some may require the operator to mon
