Electronics Forum | Tue Dec 18 04:13:27 EST 2018 | bukas
hello everyone, i'm looking for a spray gun that can withstand flux aggression. I made air controlled prototype for ersa wave machine, but air guns wear out quickly and start to leak. I was thinking about Binks model 95AR or something with stainless
Electronics Forum | Mon Nov 16 06:54:21 EST 1998 | Michel SORGIUS
I buy 6 spray system by ERSA (http://www.ersa.de)in new solder wawe but also in retrofit. We had a very good experience whith this system. We used INTERFLUX has low residues flux. (IF2005M) This is a belgium company. Good luck Michel
Electronics Forum | Wed Dec 13 15:19:32 EST 2023 | hhudson
It has been happening in the mornings, and we do have a weak middle element, but our temp is always above 60C. we have it set at 65C. the service manager for the machine assured us that temperature wasn't the issue. Also, our flux application for ERS
Electronics Forum | Fri Apr 20 10:17:47 EDT 2018 | sarcher
We purchased a ERSA Wave Solder 330-F machine recently "As Is", with NO warranty. Trying to get the machine started, we've ran into trouble with the Spray Fluxer ESF. During the initial verification run, the spray fluxer would move 4 times to the ce
Electronics Forum | Tue Jul 29 12:51:40 EDT 2008 | grics
I am having some problems with some of my pcbs at ive solder. We are using an ersa versaflow. It has an automated spot/spray fluxer (Interflux Pacific 2009M) , 1 preheat stage, a leaded pot/nozzel, and finally a lead-free pot/nozzel. Nozzels move, b
Electronics Forum | Thu May 07 08:12:06 EDT 2009 | milroy
Hi I recommend you to check the exhaust sensor, the ERSA EWS500F is sensing the exhaust before it activates the fluxer. If the exhaust is not working then machine does not start to avoid the sprayed flux emit to the work environment. There is a sens
Electronics Forum | Fri Nov 29 10:26:01 EST 2019 | marwan
flux my leave a white residues even after cleaning, when we want to select a flux for our Ersa Ecoslect we tryed a varity of fluxes (including the IF2005C) and we decide to use the Cobar 390-RX-HT because he gaved us the best results in soldering and
Electronics Forum | Thu Sep 01 02:47:01 EDT 2005 | stalkerb
Thanks Cmiller & PR, I am warmed to hear others are doing this sort of thing.......like all inovative ideas, you often stumble into them. As far as im aware the ERSA dual Pot is the only machine avaiable on the market that can do this sort of thing
Electronics Forum | Wed May 06 08:15:39 EDT 2009 | xinxi
Hi all, I understand that this forum is more to surface mount discussion. But I am eager in sorting out the spray fluxer problem. Please provide me with any ideas that you think might cause it. I have a problem in starting up/initialising the wave
Electronics Forum | Tue Aug 30 10:48:18 EDT 2005 | cmiller
If you do not have a lot of TH joints there are some advantages. No boards "submarined" in solder pot on wave. You can solder the bottome side SMT parts rather than epoxy them when the parts are put down. This should reduce SMT defects and missing pa
winsouce.jpg)
