Electronics Forum | Fri Mar 22 03:19:43 EDT 2019 | bukas
well, in video shown it looks like #1 motor drives head #1 upwards but does not detect home sensor being triggered. and then you get timeout error, head not being able to reach the position ( machine not registering it has reached position). since yo
Electronics Forum | Fri Mar 16 16:08:03 EDT 2012 | burb1999
Looking for the best Selective wave from everybodies opinions and why? Looking at also if it needs fixtures etc? What about the ERSA VERSAFLOW 3/45? Thanx, Todd
Electronics Forum | Thu Nov 01 12:58:40 EDT 2012 | bburn
My company is looking to purchase a new selective solder system. We're currently looking at the ACE KISS 205 and the ERSA Versaflow3. I am hoping to get some feedback from anyone who has worked with either of these machines or the companies themsel
Electronics Forum | Wed Feb 08 22:05:54 EST 2017 | cromaclear
Hello to all, I am using ersa versaflow 3 selective soldering machine, i am having problems with nitrogen gas ring contamination. How can i clean this rings,what do you use? Ultrasonic bath maybe?
Electronics Forum | Sat Mar 11 08:37:35 EST 2017 | tch
My company has had the same issue on our Versaflow 366 with SAC305, we tried ultrasonic cleaning and it worked for a shift and then was clogged again. We have had the machine for 3 years and we have had to replace the gassing rings twice so far. We a
Electronics Forum | Thu Apr 20 02:17:15 EDT 2017 | cromaclear
Hello to all, I am having a serious problem on my ersa versaflow 3 machine. This is a selective soldering machine and a problem is in less soldering material on the pins, you can see it in the picture http://imgur.com/a/FC2a1 Do you have any idea how
Electronics Forum | Fri Feb 10 11:10:21 EST 2017 | duoman
I've been using the ERSA Versaflow 3/45 for 3 years. I've been changing the gassing rings and seals annually, but I'm going to a schedule of every 6 months. I blow my gassing rings off with compressed air. I also blow a little into the intake tube to
Electronics Forum | Mon Apr 01 03:55:59 EDT 2019 | robl
Hi Lee, Depends on the pitch, but 3 main options: 1) Use solder preforms and intrusively reflow https://www.indium.com/solders/preforms/ 2) Use a selective solder machine on smallest nozzle or Robot with fine tip. Our Versaflow 3/45 can handle the
Electronics Forum | Thu Jun 29 10:45:46 EDT 2006 | stepheniii
We have an ERSA Versaflow Ecoselect selective wave soldering machine. It works well except it needs nitrogen. You can't even move the table around if your nitrogen tank is empty. The spec sheet says Required degree of purity: Nitrogen liquid 5.0
Electronics Forum | Sat Jun 24 07:23:06 EDT 2017 | tch
You will need to preheat the boards for a lead free selective solder process. A preheat module is critical for any wave or selective solder process, if you don't get the board preheated properly the solder is going to resist flowing to the top of the
.png)
