Electronics Forum | Wed Jan 11 14:51:05 EST 2006 | j keller
we have a new ersa ews500 wave machine and are experiencing difficulty in profiling for lead free. particular issue is reaching 110c preheat for large TH electrolitic caps while maintaining 110-170c on 1/4 watt resistors in same area
Electronics Forum | Wed Jan 11 16:56:15 EST 2006 | russ
So are you saying that you cannot reach 110C at 1 location without raising another location to excessive preheat temp? If so, sometimes slowing down the conveyor and dropping the preheat temps will help you get equal temps. I do not know this machi
Electronics Forum | Fri Jan 13 12:12:48 EST 2006 | jimk
we have 4 bottom IR heaters and a 2 zone bottom Quartz heater (2 lamps/4 lamps) and 1 convection heater above zone 1 IR. we have very tight restrictions from customer and I could send profile view to your email if possible
Electronics Forum | Fri Jun 02 11:07:45 EDT 2017 | soldertraining
I think SEHO GoWave 1030 is better than ERSA ETS 330. The SEHO GoWave 1030 is a powerful soldering system for mass soldering applications. It's used for all types of soldering.
Electronics Forum | Thu May 18 04:28:43 EDT 2017 | bukas
hello everyone, I need to choose between ERSA ETS 330 and SEHO GoWave 1030. can you please tell me your experiences with these machines? thank you very much.
Electronics Forum | Wed Aug 02 12:04:42 EDT 2017 | davejohnson
Hopefully not too late of a reply... We currently have both, the Ersa ETS 330 (running LEAD solder) and Seho GoWave 1030 (RoHS solder). Bought the Ersa used, and it seems like a strong built industrial high volume machine. We've needed to modify it a
Electronics Forum | Wed Jul 19 02:37:24 EDT 2017 | bukas
Hello everyone, i recently got Ersa ETS 330 wave machine '94. I got it running and heaters and flux pumps are ok, but I have problem with 2nd wave pump. It runs for 10-15 sec and then shuts down with error message on display. I checked bearings and
Electronics Forum | Thu Dec 29 11:43:46 EST 2005 | samir
CMiller, Thanks for the valuable info! We are in the midst of lead-free deployment and need to know good alloy choices at both wave and ERSA. I have heard the same things regarding SAC305's price for bar solder, but don't yet know what the process
Electronics Forum | Thu Dec 29 11:54:31 EST 2005 | Cmiller
We bought the lead free pots for the Ersa machine and change back and forth. We had a lot of problems running SAC305 in the Ersa. It seems to create a ton of dross and you need to frequently clean and flux the nozzles. I would really like some feed
Electronics Forum | Mon Nov 05 00:51:58 EST 2007 | omidjuve
We have a problem with soldering of a 96 pin header connector(9001-11961c00l1a from kingmate) we use 3 different wave soldering but in all of the machines we have many short circuit between the pins . the wave soldering machines that we use is fr
.jpg)
