Electronics Forum | Wed Jan 11 14:51:05 EST 2006 | j keller
we have a new ersa ews500 wave machine and are experiencing difficulty in profiling for lead free. particular issue is reaching 110c preheat for large TH electrolitic caps while maintaining 110-170c on 1/4 watt resistors in same area
Electronics Forum | Wed Jan 11 16:56:15 EST 2006 | russ
So are you saying that you cannot reach 110C at 1 location without raising another location to excessive preheat temp? If so, sometimes slowing down the conveyor and dropping the preheat temps will help you get equal temps. I do not know this machi
Electronics Forum | Fri Jan 13 12:12:48 EST 2006 | jimk
we have 4 bottom IR heaters and a 2 zone bottom Quartz heater (2 lamps/4 lamps) and 1 convection heater above zone 1 IR. we have very tight restrictions from customer and I could send profile view to your email if possible
Electronics Forum | Fri Jun 02 11:07:45 EDT 2017 | soldertraining
I think SEHO GoWave 1030 is better than ERSA ETS 330. The SEHO GoWave 1030 is a powerful soldering system for mass soldering applications. It's used for all types of soldering.
Electronics Forum | Wed Aug 02 12:04:42 EDT 2017 | davejohnson
Hopefully not too late of a reply... We currently have both, the Ersa ETS 330 (running LEAD solder) and Seho GoWave 1030 (RoHS solder). Bought the Ersa used, and it seems like a strong built industrial high volume machine. We've needed to modify it a
Electronics Forum | Thu May 18 04:28:43 EDT 2017 | bukas
hello everyone, I need to choose between ERSA ETS 330 and SEHO GoWave 1030. can you please tell me your experiences with these machines? thank you very much.
Electronics Forum | Sun Apr 12 21:37:52 EDT 2009 | padawanlinuxero
HI !!! We have the same oven! and yes profiling is hard, but not that bad. Check with the solder paste company for information, right out of my head dont remember for the temps that we use on mondayIcan show you my profile so that youhave an idea
Electronics Forum | Mon Apr 13 12:32:55 EDT 2009 | ericthered
That would be great Armando, thanks. Also, what changes might I make with metal clad light boards (LED). heat transference is tricky with these and the solder is not wetting well.
Electronics Forum | Fri Mar 27 10:04:51 EDT 2009 | ericthered
We have been having problems with proper wetting when running mainly lead free but also leaded solder in our Ersa Hotflow 3. Solder either often looks grainy or doesn't flow over the whole pad. This is generally the case when my profile is 170 firs
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
