Electronics Forum | Sun Feb 23 14:51:02 EST 2003 | davef
Without being clear on whether you're talking about: * Standard air knives at the back-end of your in-line cleaner ... OR * Hand held or similar nozzle. Standard air knives: This causes no problem with ESD because the relative humidity is so high t
Electronics Forum | Fri Feb 21 16:08:56 EST 2003 | clarkk
Hello all, We use pressurized air from a blower to blow off excess water from our pcb assemblies after wash. I'm concerned that this could potentially cause esd damage to sensitive assemblies. Is anyone aware of a device that can correctly ionize the
Electronics Forum | Mon May 06 05:32:39 EDT 2013 | pavel_murtishev
Jim, Thank you for the input. Could you please check your standard filter pore size? A model number would be valuable. How many shop volumes (in cubic meters) do you pump per hour? Customer is seriously thinking over installing AC system similar to
Electronics Forum | Mon May 06 21:40:40 EDT 2013 | davef
ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity limits
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Wed Feb 03 16:52:33 EST 2010 | kennyg
Is the use of a 'canned air' product on a PCBA an ESD concern; such as the techspray "duster" cans? Is there such thing as an ESD safe canned air product?
Electronics Forum | Tue Mar 18 01:18:15 EST 2003 | ereznahoum
Hi, I have to protect A small 3v battery power circuit with 2 layer PCB in plastic box against �Air ESD�. What is the best PCB layout for this purpose.
Electronics Forum | Tue Apr 11 17:45:02 EDT 2000 | Ashok Dhawan
I am looking for an appropriate method to dry wave soldered boards. While board assemblies are passed through board cleaning station , they are not fully dry . We do not want to heat above 180 deg F to dry them completely. We think that air drying u
Electronics Forum | Fri Mar 24 13:02:53 EST 2000 | Ashok Dhawan
Two questions on ESD: 1. What is recommended method ( Air ionizer , grounding strip etc. ) for a board prep ? We Kapton Tape for masking pads or not to be soldered areas. or Is there a wet mask recommended for masking boards campatible with NC Sold
Electronics Forum | Thu Sep 25 09:13:21 EDT 2003 | davef
Pete: That ACL Staticide� is used on the bulb of the Arach Technology & Application Corp Vacuum Pen� to attain ESD proprties, make us uneasy. "Staticide" is a topical anti-static solution. It's a soap that absorbs moisture from the air to improve
