Electronics Forum | Thu Jan 29 16:52:53 EST 2004 | davef
Air Power distributer Pyles caulking guns. One Air Power office is: Air Power, Inc. 107 Woodruff Industrial Lane Greenville, SC 29607 Phone: (864) 234-5456 Toll Free: (888) 731-4836 Fax: (864) 281-0545 Henry Sutherland, Branch Mgr. We have no rela
Electronics Forum | Tue Dec 18 04:13:27 EST 2018 | bukas
hello everyone, i'm looking for a spray gun that can withstand flux aggression. I made air controlled prototype for ersa wave machine, but air guns wear out quickly and start to leak. I was thinking about Binks model 95AR or something with stainless
Electronics Forum | Sun Feb 23 14:51:02 EST 2003 | davef
Without being clear on whether you're talking about: * Standard air knives at the back-end of your in-line cleaner ... OR * Hand held or similar nozzle. Standard air knives: This causes no problem with ESD because the relative humidity is so high t
Electronics Forum | Mon Oct 16 16:01:42 EDT 2006 | timnop
I have a wave machine (offshore made) with internal spray fluxer configured with a conventional spray gun set up. In order to spray fluid (in this case, flux) I must set the air pressure at 0.3 mPA (43 PSI). At that pressure, my flux sprayer creates
Electronics Forum | Fri Nov 05 13:58:23 EDT 2010 | chartrain
I agree that the tines (webs between apertures) can become damaged on fine pitch stencils from a blast of air. If they get bent, the stencil won't seat and gasket properly allowing bleed out of paste. Of course we all know that the air being blasted
Electronics Forum | Fri Feb 21 16:08:56 EST 2003 | clarkk
Hello all, We use pressurized air from a blower to blow off excess water from our pcb assemblies after wash. I'm concerned that this could potentially cause esd damage to sensitive assemblies. Is anyone aware of a device that can correctly ionize the
Electronics Forum | Mon May 06 05:32:39 EDT 2013 | pavel_murtishev
Jim, Thank you for the input. Could you please check your standard filter pore size? A model number would be valuable. How many shop volumes (in cubic meters) do you pump per hour? Customer is seriously thinking over installing AC system similar to
Electronics Forum | Mon May 06 21:40:40 EDT 2013 | davef
ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity limits
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Fri Mar 24 13:02:53 EST 2000 | Ashok Dhawan
Two questions on ESD: 1. What is recommended method ( Air ionizer , grounding strip etc. ) for a board prep ? We Kapton Tape for masking pads or not to be soldered areas. or Is there a wet mask recommended for masking boards campatible with NC Sold
